Info |
---|
|
This configuration only applies to (and is visible in) SBC SWe virtualized deployments. |
Use the Ems window to specify the EMS
with which the SBC will register.
If the SBC is currently registered with an EMSa , its IP address is shown.To enable dynamic enable dynamic Service Discovery of the EMS IP address, you Address you must specify a fully qualified domain name (FQDN) as the target for EMS
registration. By using Service Discovery and an FQDN, the SBC can maintain registration with an EMS server without the need for re-initiating whenever
an EMS a IP address changes.
For For more information on using Service Discovery, refer
to to Service Discovery for Trap Target Destinations and EMS RAMP Registration.
This configuration applies and is visible only in SBC SWe virtualized deployments.
To View
EMS RAMP Configuration
On the SBC main screen, go to All > System > Ems
The Ems window opens.
Figure 1: Ems Window
To Edit
EMS RAMP Configuration
To specify
an EMS a
FQDN:- In Ems FQDN, enter an FQDN of up to 128 characters
- Click Save.
The following table describes the parameters on in the Edit EMS window (above).
Table 1: Edit Ems Parameters
Parameter | Description |
---|
Ems IP Address | Displays the IP address of |
an EMS a with which the SBC is currently registered. |
Ems FQDN | Specifies an FQDN (up to 128 characters) of the |
EMS server to use for EMS registration. Refer |
to Target EMS RAMP Registration for information on FQDN naming conventions. Changing this value requires an SBC reboot to take effect. |
You cannot copy or delete EMS a configuration.