Press ENTER. The system automatically executes the initial configuration procedure.
Tip
title
Tip
After the system executes the initial configuration for Node 1, you must execute this procedure for Node 2 in the mated pair configuration. Make sure to select 2 - Mated Pair as Node 2 and enter the IP addresses you configured for Node 1.
You are prompted to decide whether EMS access should be enabled on the system that you are configuring.
If you want to have EMS access enabled, press y, and press ENTER, and go to step c.
If you do not want EMS access enabled, go to step d.
If you pressed y and and ENTER in step a, the system enables EMS access and executes the initial configuration procedure, and restarts the Web UI.
If you do not want to enable EMS access, enter n, and press ENTER. A message appears informing you that EMS access was not enabled (EMS snmp rw community string was not activated), and the system continues to automatically execute the initial configuration procedure and restart the Web UI.
Tip
title
Tip
If, at a later time, you want to enable EMS access, refer to Enabling EMS.
Tip
title
Tip
You have to wait approximately five minutes before you can access the Main Menu in Web UI after the system completes the execution of the initial configuration procedure.