...
Include Page |
---|
| IP_IGs_ServedBySeperateProcessors |
---|
| IP_IGs_ServedBySeperateProcessors |
---|
|
Command Syntax
For SBC 5xx05400/7000/SWe:
Code Block |
---|
|
% set addressContext <addressContext_name> zone <zone_name> gwSigPort <#>
ipAddress <IPv4 or IPv6 address>
ipInterfaceGroupName <name>
mode <inService | outOfService>
portNumber <#>
role <primary | secondary>
state <disabled | enabled> |
...
Caption |
---|
0 | Table |
---|
1 | Zone Gateway Signaling Port Parameters |
---|
|
|
Parameter | Length/Range | Description |
---|
zone
| 1-23 characters | The name of the zone. For GW-to-GW calls, the zone must be “defaultSigZone”. |
gwSigPort
| 1-2048 | Gateway (GW) signaling port index number. For gateway signaling the value must be 1. ipAddress – IP address of the gateway signaling listening port, either in IPv4 or IPv6 format.
Note |
---|
An IPv4-mapped IPv6 address is not allowed. |
ipInterfaceGroupName – Name of IP interface group used by the gateway signaling port.ipVar – Metavariable name associated with the gateway signaling port IP address. The ipVar parameter is used to configure the gateway signaling IP address in SBC SWe N:1 HA or cloud-based deployments. Note: You can view this parameter only for cloud-based SBC SWe I-SBC and D-SBC deployments. mode – The operational mode of the gateway signaling port.inService (default)outOfService
portNumber – TCP port number of gateway signaling port (default = 2569).role – Role of the gateway signaling port.primary – (default) Creates a port for gateway signaling traffic.secondary – An alternate port used for listening only and cannot be used to establish new gateway signaling links.
state – Administrative state of gateway listening port. disabled (default)enabled
|
CLI Examples
To configure the gateway signaling port on SBC 5xx05400/7000/SWe, execute the following commands:
...