Page History
...
- If the SBC is running, press and hold the Reset button for approximately 20 seconds.
Shut down the SBC, press and hold the reset button while the unit is powered on. Hold the reset button until the Alarm Status LED first turns yellow and then goes out.
Expand title Click here to see where the Sonus SBC 1000 Reset button is located Click here to see where the Sonus SBC 1000 Reset button is located Caption 0 Figure 1 SBC 1000 Reset Button Expand title Click here to see where the Sonus SBC 2000 Reset button is located Click here to see where the Sonus SBC 2000 Reset button is located Caption 10 Figure SBC 2000 Reset Button
After the SBC system has booted, it can be re-initialized by Running Initial Setup.
...
- In the WebUI, click the Tasks tab.
In the left navigation pane, go to System >
Factory Default.Spacevars 0 product Panel borderStyle none Caption 0 Figure 1 Factory Default for SBC 1000/2000 and SBC SWe EdgePanel borderStyle none Caption 10 Figure Factory Default for Cloud Native SBC SWe Edge
Operation Selections
Factory Default
...
...
bgColor | #FAFAFA |
---|---|
borderStyle | none |
This selection performs a total factory reset. After the operation
...
completes,
...
you can
...
re-
...
initialize the SBC by Running Initial Setup.
Partial Reset
...
...
bgColor | #FAFAFA |
---|---|
borderStyle | none |
This selection removes all configuration information from the SBC with the exception of the Logical Interfaces, Ethernet ports, VLANs, ACLs, Static Routes, ASM Networking, Node-Level Settings and Certificate configurations.
...
you can reach this SBC option
...
through a browser pointed at its application IP
...
address.
Pagebreak |
---|