Page History
Add_workflow_for_techpubs | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
|
It is assumed that before you execute the procedure presented in this page, you have completed the following tasks:
- configured the system licensing (refer to Licensing the DSC SWe for KVM)
- configured the Hostname and Domain Name (refer to Configuring the Hostname and Domain Name)
- configured the management and IP routing interfaces [refer to Configuring the Network Management Interfaces (IPv4, IPv6) and Configuring the IP Routing and IMF Traffic Interfaces, respectively]
Info | ||
---|---|---|
| ||
If your system is licensed for PCE, the initial configuration must be done on all slots. If not, execute the initial configuration on one ROUTING_MGMT VM. All other VMs will be updated accordingly. |
...
MultiExcerptName | Prerequisite Initial Config |
---|
After you have completed the initial configuration procedures described in this section, if required, you can change the default Point Code Emulator (PCE) NA values to any unique value from 1 to 99. The default PCE NA settings are recommended unless they are already in use by existing configurations and the PCE support creates a conflict. The PCE supports Basic and Enhanced licensing options. A Basic license allows for one public (NA 1) and one private (NA 2) network. The Enhanced license allows for one public (NA 1) network and two private networks (NA 2 and NA 3). The Enhanced PCE is used in networks that are migrating traffic from an existing switch to a new switch. In this configuration, the existing switch and the new switch may have the same Local Point Code (LPC) and are able to transmit SS7 signaling to one another.
For more information about PCE, refer to the appropriate section in the SS7 Application Guide 2.
...
Use the following procedure to configure the system once the initial install has completed. The initial configuration procedure must be executed using the Menu UI. For detailed information about the Menu UI, refer to Web UI and Menu UI Guide.
...
It is assumed that you are logged onto the DSC before executing the following procedure.
...
title | Note |
---|
...
Prerequisites
- Before you execute this procedure, complete the tasks as listed in Configuring and Initializing the DSC SWe
Anchor | ||||
---|---|---|---|---|
|
...
Multiexcerpt | ||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||||
Start
|
...