Panel | ||||
---|---|---|---|---|
In this section:
|
Perform the following steps to redirect the ISO file.
Click Virtual Machines, and click the VM that you want to configure. Caption
Include Page | ||||
---|---|---|---|---|
|
Expand the CD/DVD Drive 1 drop-down menu. 0 Caption
Figure
In the CD/DVD Media field, click Browse... 0 Caption
Figure
Navigate to the ISO file and click Select. 0 Caption
Figure
Perform the following steps to install the SBC SWe OS.
Click Power on to power on the VM that has the ISO file. 0 Caption
Figure
Include Page | ||||
---|---|---|---|---|
|
The ConnexIP Installer window is displayed. Press Enter. 0 Caption
Figure
6 ConnexIP Installer
0You are prompted to enter the login credentials once the installation is complete. Caption
Figure
Log onto on to the CLI as linuxadmin
. The system prompts you for the following IP addresses:
Note |
---|
Make sure you enter the exact primary management IPv4, network mask, and gateway IP details. You will have to reinstall the OS if the details are incorrect. |
Primary Management IPv4 Address
Primary Management Network Mask
Primary Management Gateway IP Address
IPv6 Address. Press y
and enter the IPv6 address if you want to set IPv6. Press n
if you do not want to set IPv6.
Info |
---|
The IPv6 address for management can be configured only in this step. |
Figure
Perform the following steps to verify the MAC Addresses.
Click Console and select an option to open the console. 0 Caption
Figure
Include Page | ||||
---|---|---|---|---|
|
Execute Run the following command to retrieve the mapping MAC address:
Code Block |
---|
ifconfig -a |
Execute Run the following command to retrieve the specific interface MAC address for the management interface:
Code Block |
---|
ifconfig mgt0 |
Info |
---|
If you have other network interfaces configured for NIC teaming, repeat this step to retrieve the MAC addresses (refer to Configure the NIC Teaming). |
Note the mapping MAC address for each interface and then exit the console. 0 Caption
Expand the Network Adapter drop-down menus and verify that the MAC addresses map to the correct network interfaces.
Note |
---|
In the Status field, do not uncheck the Connect at power on the box. |
Note | ||
---|---|---|
| ||
If you are using a wide-area or low-bandwidth connection, the time delay over the network may cause the virtual machine to start autorepeat. This can manifest in unintended repeated keystrokes when typing in a remote console. If you experience this issue, refer to the VMware Knowledge Base for a solution. |
Figure