Use the DSP Call Interval Statistics window to view system DSP resource statistics, in terms of calls, for a series of statistics intervals. To set the statistics time interval and the number of intervals to report, refer to System - Interval Statistics.
On the SBC main screen, go to Monitoring > System > Category: System Status and Statistics > DSP Res > DSP Call Interval Statistics or
All > System > DSP Res > DSP Call Interval Statistics
The DSP Call Interval Statistics window is displayed.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | DSP Call Interval Statistics |
|---|
|
|
The following output is displayed:
| Caption |
|---|
| 0 | Table |
|---|
| 1 | DSP Call Interval Statistics |
|---|
|
| Parameter | Description |
|---|
| Number | Specifies a sequence number which identifies the interval for which the set of statistics is shown. | | System Name | The node name. | | Interval Valid | A setting of 'true' indicates the interval contains valid data during the time interval. Each interval is for a configurable fixed time (default interval is 15 minutes) starting on the hour. For example, if the system starts at 12:05, the first interval at 12:15 will not be valid because it is less than the 15-minute interval. Subsequent intervals will be valid upon meeting the 15-minute time interval. System switch-overs also cause invalid intervals because data is lost during the interval. | | Time | System up time when the interval statistics were collected. | | Num Call Success No DSP Alloc Failure | Number of successful calls without DSP resource allocation failure for the specified statistics interval. | | Num Call Success With DSP Alloc Failure | Number of successful calls with DSP resource allocation failure for the specified statistics interval. | The table contains three columns for each codec: - Num Call Fail No <codec> – Number of calls failed due to lack of DSP resource for the specified codec for the specified statistics interval.
- Num Call Fail Other On <codec> – Number of call fails due to reason other than lack DSP resources for the specified codec for the specified statistics interval.
- Num Call Success No <codec>– Number of successful calls even though lack of DSP resources for the specified codec for the specified statistics interval.
The following codecs appear: - G729
- G726
- G711Packet
- G723
- Ilbc
- Evrcb0
- Amr
- Amrwb
- G722
- Tone
- Evrc
- G7221
- Efr
- Opus
- Silk8
- Silk16
|
|