Page History
Add_workflow_for_techpubs | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Panel | ||||
---|---|---|---|---|
In this section:
|
Include Page | ||||
---|---|---|---|---|
|
Info | ||
---|---|---|
| ||
To recover from the default indices, refer to MOP to Recover from Mismatch in 1:1 SBC SWe HA Session Estimates, if applicable. |
This section describes the different methods to upgrade the
Spacevars | ||
---|---|---|
|
When an
Spacevars | ||
---|---|---|
|
Prerequisities
Prior to performing an upgrade on the
Spacevars | ||
---|---|---|
|
For
(in general): Spacevars 0 series4
- Before upgrading the ConnexIP OS, firmware, and the
application, you must first save the configuration in case you encounter any issues during the upgrade.Spacevars 0 product - This will allow you to restore the system and continue the upgrade.
- Refer to Saving the SBC Configuration and Restoring SBC Configuration.
Before upgrading the application, upgrade the SBC firmware to the latest version on both the active and standby SBCs for an HA pair.
- Refer to the target Release Note for the latest firmware version.
- Upgrade the firmware using Upgrading BMC Firmware procedure.
For
: Spacevars 0 product2
Increase the memory to the larger of:
- the minimum memory required for the release.
or - the memory required for the desired session capacity.
instances configured with only 12 GB of RAM have lower capacity limits than instances with higher memory configurations, thus they may not perform at optimum capacity. Contact your Ribbon representative to order DIMM kits to increase the RAM to 24 GB.ForInfo title Note The performance/capacity of the
Spacevars 0 product2 Spacevars 0 product2
, andis impacted by the amount of memory assigned to the VM. Review SBC SWe Performance Metrics to see the memory requirements for the current release
refer to SBC SWe Performance Metrics.plus a procedure to upgrade memory,
if required. Complete the procedure to upgrade memory prior to performing the upgrade.
- the minimum memory required for the release.
- Ensure the
memory reservation meets the requirements for the current release. Refer to SBC SWe Performance Metrics.Spacevars 0 product2
Multiexcerpt include | ||||
---|---|---|---|---|
|
Live Software Upgrade (LSWU)
LSWU allows a user to upgrade the
Spacevars | ||
---|---|---|
|
Spacevars | ||
---|---|---|
|
Spacevars | ||
---|---|---|
|
Non-Live Software Upgrade (Non-LSWU)
The non-LSWU upgrade process requires taking the SBC system offline to perform an application upgrade. This refers to upgrading the
Spacevars | ||
---|---|---|
|
Info | ||
---|---|---|
| ||
Once the upgrade is complete, rediscover the SBC from the EMS, if present, and edit any attributes that may have been modified post-upgrade. Attributes are listed under the EMS page Register an SBC Core Node. |
Pagebreak |
---|