Page History

...

1. In the WebUI, click the Settings tab.
2. In the left navigation page, access Signaling Groups
   

3. From the Create Signaling Group drop down box, select SIP Signaling Group.

4. Configure the parameters as shown below. Leave the default values for all other parameters.

5. Click OK.
   

   Caption0Table1

   
   

   Signaling Group Configuration - Example Values

   Parameter	Value
   RTCP Multiplexing	Enable
   ICE Support	Enabled
   ICE Mode	Lite
   Outbound NAT Traversal*	Static NAT
   NAT Public IP (Signaling/Media)*	Public Address for the NAT device assigned on the media port for your network
   Static NAT Inbound	Disabled

   *Outbound NAT Traversal and the NAT Public IP is required when the SBC is behind a NAT (the public IP address of the NAT device is required when the SBC has a Private IP).

   
   

   Note
   The peer endpoint must support the a=rtcp-mux exchange in order for the RTP and RTCP ports to be multiplexed into one data port.

   Pagebreak

   Caption0Figure1
   
   SIP Signaling Group - Example

   Image Modified