Page History
...
From the Create CAS Profile drop down box at the top of the CAS Signaling Profile Table Page, select FXO Profile.
Panel borderStyle none Caption 0 Figure 1 Create CAS Loop Start FXO Profile Anchor properties properties
...
Panel | ||||||
---|---|---|---|---|---|---|
| ||||||
Specifies the signaling type for the Loop Start Type. The options are as follows:
|
DTMF On Time
Panel | ||||
---|---|---|---|---|
| ||||
Specifies the duration, in milliseconds, that the tones are on. |
...
Panel | ||||
---|---|---|---|---|
| ||||
Specifies whether or not a dial tone must be detected before dialing out. |
...
Minimum Forward Disconnect Duration
Panel | ||||
---|---|---|---|---|
| ||||
Specifies the time which qualifies as a valid forward disconnect (battery removal). Valid only when Loop Start Type is set to "Forward Disconnect". |
...
Panel | ||||
---|---|---|---|---|
| ||||
Enables and disables the supervision that disconnects a call following silence for the length of time defined in the Silence Based Disconnect Timer field. Silence is detected only on the audio stream coming into the FXO interface side of the call. | ||||
0 | Figure |
Silence Level
Panel | ||||
---|---|---|---|---|
| ||||
The level below which line noise must remain to qualify for silence. This field is only visible when Silence Based Disconnect supervision is enabled. |
...