Page History
Parameters
| Parameter Name | Required | Service Affecting | Data Type | Default Value | Possible Values | Description | ||
|---|---|---|---|---|---|---|---|---|
| Description | No | No | string | none | 64 - Max Length | Meaningful name for the profile. | ||
| VoiceFaxProfileID | Yes | No | string | 1 | 200 - Max Length | Identifies a comma separated string of the Media Profile IDs to be used in this profile. | ||
| CryptoProfileID | No | No | int | 0 | Possible values:
| Identifies a cryto profile ID used. If no crypto profile is used then this is set to 0. | ||
| DtlsProfileID | No | No | int | 0 | Possible values:
| Identifies a DTLS profile ID used. If no DTLS profile is used then this is set to 0. | ||
| DeadCallDetection | No | No | Enum | 0 | Possible values:
| To turn on and off the DCD feature based off of RTCP. | ||
| DSCP | Yes | No | int | 46 | Possible values:
| The DSCP value to be used in the IP header of media packets from the SBC Edge, for calls that use this Media List | ||
| ReceiveGain | Yes | No | int | 0 | Possible values:
| Specifies the gain or loss in decibels to apply to received signals. Rx gain implies the gain of signal from Packet to PCM side. This is applicable only for the SBC 1000/2000 platforms. | ||
| TransmitGain | Yes | No | int | 0 | Possible values:
| Specifies the gain or loss in decibels to apply to transmitted signals. Tx gain implies the gain of signal from PCM to Packet side. This is applicable only for the SBC 1000/2000 platforms. | ||
| SilenceSuppression | No | No | Enum | 0 | Possible values:
| To turn on and off the Voice Activity Detection and send PT13 packets when on. | ||
| ComfortNoiseTDM | No | No | Enum | 0 | Possible values:
| Not used. | ||
| DigitRelayType | Yes | No | Enum | 1 | Possible values:
| Specifies the digit relay type to use.
| ||
| DigitRelayPayloadType | Yes | No | int | 101 | Possible values:
| Specifies the payload type used for RFC 2833 packets.
| ||
| ModemRelay | Yes | No | Enum | 0 | Possible values:
| Specifies if modem passthrough is enabled when using the G.711 codec. This is applicable only for the SBC 1000/2000 platforms. | ||
| FaxRelay | Yes | No | Enum | 0 | Possible values:
| Specifies if fax passthrough is enabled when using the G.711 codec. This is applicable only for the SBC 1000/2000 platforms. | ||
| CNGToneDetection | Yes | No | Enum | 0 | Possible values:
| Specifies if the system should detect fax calling tones. This tone is produced by the origination side fax machine. This is applicable only for the SBC 1000/2000 platforms. | ||
| CNGNumberOfCycles | Yes | No | int | 2 | Possible values:
| Specifies the number of cycles that must be detected by the system before it considers the tone to be a valid CNG tone. 1 to 5 are valid values. This is applicable only for the SBC 1000/2000 platforms.
| ||
| FAXToneDetection | Yes | No | Enum | 1 | Possible values:
| Specifies if the system should detect fax(V.21 flag) tone. This tone is produced by the terminating side fax machine. This is enabled for SBC 1000/2000 and disabled for Swe Lite by default. | ||
| MediaRTCPMode | Yes | No | Enum | 0 | Possible values:
| Specifies if RTCP-XR packet type can be used in RTCP channel. If XR is chosen make sure the remote end can support XR RTCP frames. This is applicable only for the SBC 1000/2000 platforms. | ||
| DtmfSignalToNoise | Yes | No | int | 0 | Possible values:
| Controls the minimum Signal to Noise ratio threshold (in decibels) for the DTMF detector. This is applicable only for the SBC 1000/2000 platforms. | ||
| DtmfMinimumLevel | Yes | No | int | -38 | Possible values:
| Controls the minimum level (dBm0) for each of the received DTMF components. This is applicable only for the SBC 1000/2000 platforms. |
Overview
Content Tools