Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_workflow_for_techpubs
AUTH1UserResourceIdentifier{userKey=8a00a0c86e9b2550016ec54396b5000a, userName='null'}
JIRAIDAUTHSBX-110729
REV5UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb8305e9, userName='null'}
REV6UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb8305e9, userName='null'}
REV3UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26c99f02ce, userName='null'}
REV1UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb5d05b3, userName='null'}


Warning

The Bidirectional Forwarding Detection (BFD) is not supported in SBC versions 8.2

...

.1 (and later), 9.

...

x and 10.

...

x.

The 

Spacevars
0product
uses Bidirectional Forwarding Detection (BFD) in remote end points and routers to continuously monitor the link availability of the
Spacevars
0product
. If the BFD session is down, the router declares the link as down and the upper layer application protocol performs the appropriate actions (such as, not sending control packets).

Info
titleNote

The

Spacevars
0product
supports this feature only on User Datagram Protocol (UDP) and IPv4.

This feature does not support any authentication mechanism.

The

Spacevars
0product
supports the BFD asynchronous mode. In the asynchronous mode, the detection time decides the failure of the BFD session.

The detection time indicates the time interval when the

Spacevars
0product
does not receive BFD packets, which means the BFD session fails. The receiving system calculates the detection time independently in each direction based on the negotiated transmit interval and the detection multiplier. Each direction may have different detection times.

The

Spacevars
0product
applies rate limits on the BFD port to avoid Denial of Service (DoS) and Distributed DoS (DDoS) attacks. The Access Control List (ACL) limits the maximum rate to 10 packets per second. Since the
Spacevars
0product
can have VLAN-based Logical Interfaces (LIFs), the BFD session maximum is 100. The maximum number of sessions for each LIF is 10. 

The active and standby

Spacevars
0product
s run the BFD daemon, but only the active
Spacevars
0product
responds to the BFD packets received on the packet ports and LIFs.

You can configure the BFD either through the EMA (refer to IP Interface Group - IP Interface - Bfd), or in the ipInterface through the CLI (refer to IP Interface Group - CLI).