Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 2

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Include Page
SBXDOC100:_FIPS_ReleasesSBXDOC100:
_FIPS_Releases


Warning

You must reconfigure snmpv3 before enabling FIPs mode. Failure to do so could cause the SBC to crash due to excessive trap generation. Perform the following steps to reconfigure snmpv3:


Use the Fips-140-2 window to enable FIPS-140-2 mode.

...

Caption
0Table
1Users and Application Management - Fips-140-2
 


ParameterDescription
Mode


Note

Once Fips-140-2 mode has been enabled, it cannot be 'disabled' through configuration. A fresh software install that discards all prior state is required to set the FIPS-140-2 mode to 'disabled'.

The options are:

  • Disabled (default)
  • Enabled

 

...