Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_workflow_for_techpubs
AUTH1UserResourceIdentifier{userKey=8a00a0c86e9b2550016ec54396b5000a, userName='null'}
JIRAIDAUTHSBX-106599
REV5UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb8305e9, userName='null'}
REV6UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb8305e9, userName='null'}
REV3UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26ca1903b3, userName='null'}
REV4UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26ced70cb1, userName='null'}
REV1UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26c9f0036e, userName='null'}
REV2UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cba10618, userName='null'}



Panel

In this section:

Table of Contents
maxLevel4


Number of IP Addresses per Call Leg Size

The number of call legs supported for a given number of IP Addresses on different SBC platforms are as follows:

  • Spacevars
    0series2
    , assuming UDP ports 4,000 through 64,444 are configured for media port usage - See table below.
  • Spacevars
    0model5
     with 10GE interfaces - Supports a maximum of 75000 sessions, requiring 4 IP addresses per call leg.
  • Spacevars
    0product2
    - Supports a maximum of 64000 sessions, requiring 3 IP addresses per call leg.

Anchor
7000table
7000table
For 
Spacevars
0series2
media resource allocation scenarios, the 
Spacevars
0product
requires a minimum of 10 IP addresses configured to support 150,000 call legs (one Primary IP address plus 9 alternate IP addresses in non-VLAN configuration).


Caption
0Table
1Number of IP Addresses Needed to Support Call Legs


Number of Call LegsNumber of IP
Addresses
150,00010
140,0009
130,0008
120,0007
110,0006
96,0005
80,0004
64,0003
45,0002
25,0001


For example, to use 100,000 call legs you must configure at least six (6) IP addresses because five IP addresses will only allow up to 96,000 call legs through the

Spacevars
0product
.

The  

Spacevars
0series4
supports configuring up to 14 alternate media addresses. For more details, see Alternate Media IP Addresses Support.

Configuration Limits

The 

Spacevars
0series2
supports a large number of configurable objects and is capable of supporting from a few very large customers to thousands of small customers. Important details about the provisioning system include:

  • Interactive provisioning of configuration objects (such as commands typed at the CLI or entered in the EMA or EMS) does not affect call handling or capacity.
  • Provisioning behavior does not depend on the number of existing entities. The addition of the 10,000th instance is roughly comparable to adding the 1st such instance.
Note
titleCaution

Bulk or non-interactive provisioning may affect call handling. Operations such as sourcing a CLI script with many configuration commands (or even a few commands affecting particularly large objects) should only be done during a maintenance window or at non-busy-hour intervals. 

Provisioning Limits

Spacevars
0series4
provisioning limits are shown in the following table.

Info
titleInfo

 The term '5xx0' represents SBC models 5100, 5200, 5110 and 5210.


Caption
0Table
1SBC Provisioning Limits




Configuration Objects

Provisioning Limits


SBC 7000


SBC 5400


SBC 5xx0

SBC SWe
VM  Memory >= 10 GiB RAM
("small" profile)
VM  Memory ≥ 18 GiB RAM
("large" profile)
Address Contexts4,0002,0482,0481292,048
SIP Signaling Ports4,0002,0482,0481294,000
H.323 Signaling Ports2,0482,0482,048129129
SIP Trunk Groups

40,000

20,000

10,000

1,02420,000
H.323 Trunk Groups

2,048

2,048

2,048

129256
Gateway Trunks

128

128128

Maximum IP Trunk Groups
of All Signaling Types
40,00020,00010,0001,02420,000
Zones4,0002,0482,0481294,000
DNS Groups2,0482,0482,048129129
IP Interfaces4,00054,00054,000512952,0485
IP Interfaces Groups4,0002,0482,0481291,024
IP Peers40,00020,00010,0001,02420,000
Alternate Media IP Addresses
(per LIF)
254254254254

254

IP Addresses8,192
4,096

IP ACLs50,000125,000217,8242 12,800000310,5924
Dynamic Black List Entries4,0001001,000 100100
Enhanced DBL Profiles100
SIP Adaptor Profiles512512512256256512
Tone Package Profiles2,048

Surrogate Registration Profiles

AoRs for Surrogate Registrations

256

10,000

SWe Traffic ProfilesRefer to SBC SWe Traffic Profiles for details.


Footnotes

1 - Includes approximately 10,000 IP ACLs for signaling ports (2 x 4,000 SIP, 2,000 H323) and 100 IP ACLs for OAM. A maximum of 35,648 IP ACLs are allowed for users.

2 - Includes approximately 4,000 IP ACLs for signaling ports and 100 IP ACLs for OAM. A maximum of 11,232 (for SBC 51x0/52x0 series) and 17,824 (for SBC 5400) IP ACLs are allowed for users.

3 - The number of user-defined ACLs is 772.

4 - The number of user-defined ACLs is 62810,592.

5 - The maximum number of IP interfaces on a single SR-IOV packet interface is limited by the maximum number of VLANs supported on the VF.

The maximum VLANs supported on SR-IOV VF interfaces depend on NIC type/capability.

  1. For Intel X540, X550 NICs, the maximum VLANs supported on the SR-IOV VF interface is 63.
  2. For X710 with trust mode enabled, the maximum VLANs supported on SR-IOV interfaces is 63.

For the other NIC types, refer to the NIC specification provided by the vendor.


Info
titleInfo

One GiB (gibibyte) = 2^30  (1,073,741,824 bytes).


The time required to add an object to an existing configuration is immaterial (It takes much longer to actually type the command or complete the EMA/EMS fields). However, bulk loading of a large configuration from the CLI may take a substantial amount of time. 

Note
titleCaution

See cautionary note above about the potential bulk configuration loading on call handling performance. 

While the 

Spacevars
0series2
supports large limits on multiple types of configuration objects, a few typical usage scenarios exist. The length of time to bulk load a configuration depends on the size of the configuration. Consequently, four
Spacevars
0series4
profile classes are defined to give customers a rough idea for the bulk loading time relevant to their configuration:

  • 1K profile – comprised of 1,000 instances each of Address Contexts, Zones, IP Interface Groups, IP Interfaces, Signaling Ports, and Trunk Groups
  • 4K profile – comprised of 4,000 instances each of Address Contexts, Zones, IP Interface Groups, IP Interfaces, Signaling Ports, and Trunk Groups
  • 4K/10K profile – comprised of 4,093 instances of IP Interfaces, 2,048 instances each of Zones, Address Contexts, IP Interface Groups, SIP Signaling Ports, 10,000 IP Peer, and 10,000 IP Trunks (see Note below).
  • 4K/40K profile [SBC 7000 series only] – comprised of 4,000 instances each of Address Contexts, Zones, IP Interface Groups, IP Interfaces, Signaling Ports; and 40,000 Trunk Groups
Note
titleNote

If both IPv4 and IPv6 are combined on every sipSigPort on an SBC 5200, the system limits the number of sipSigPorts to 1,980.

SIPREC-based Recording Limitations

Multiexcerpt
MultiExcerptNameSIPREC Recording Limitations


Criteria/Cluster/ProfilePSXERE
Call Recording Criteria (CRC)There is no hard-coded limit on the number of CRC objects you can create.Up to 128 CRC objects are allowed.
SRS Group Cluster (SRSGC)Up to 256 SRSGC objects are allowed.Up to 256 SRSGC objects are allowed.
SRS Group Profile (SRSGP)Up to 256 SRSGP objects are allowed.Up to 256 SRSGP objects are allowed.



Maximum CLI Load Times

The following table lists the maximum CLI load times for the above profile classes.

Caption
0Table
1Maximum CLI Load Times
3Maximum CLI Load Times


Configuration ProfileMaximum CLI Load Time
1K2.5 hours

4K

4 hours
4K/10K3 hours
4/40K (7000 only)10 hours


For a system previously loaded with configuration, the start-up time also depends on the amount of configuration. The start-up time is considered the time from when the

Spacevars
0product
application is started (by PM) to the time that the
Spacevars
0product
is ready to accept calls.

Note that this start-up time is typically only relevant to standalone systems after an upgrade. For a HA system, the standby is activated to handle calls while the SBC is being started or restarted. 

Approximate Start-up Times for Standalone SBC

The following table lists the approximate start-up times for a standalone

Spacevars
0product
based on its configuration profile:

Caption
0Table
1Approximate Start-up Times for Standalone SBC


Configuration ProfileMaximum Time
to Service Ready
No configuration5 minutes
1K10 minutes
4K20 minutes
4K/10K22 minutes
4K/40K (7000 only)45 minutes

OpenStack Cloud Configuration Elements

The following table presents the number of elements that can be configured in an OpenStack environment.

Caption
0Table
1OpenStack Cloud Configuration
Configuration NameNumber of Elements

Address Contexts

149

SIP Signaling Ports

138

SIP Trunk Groups

5,000

Zones

150

IP Interfaces

150

IP Interface Groups

150

IP ACLs

148

IP-Peer

5,000

VLAN70 



Pagebreak