Versions Compared

Old Version 43

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 44

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_workflow_for_techpubs
AUTH1
JIRAIDAUTHSBX-94084
REV5
REV6
REV3
REV1



Panel

In this section:

Table of Contents
maxLevel4



Info
iconfalse

Related articles:


This section describes

Spacevars
0product2
hardware and software requirements and recommendations.

To install and configure

Spacevars
0product2
, make sure the Virtual Machine (VM) host meets the following recommended hardware, server platform and software requirements.

Warning
titleWarning

The recommended hardware and software settings are intended to ensure optimum 

Spacevars
0product2
stability and performance. If the recommended settings are not used, the
Spacevars
0product2
system may not behave as expected.

Pagebreak

SBC SWe for VMware – Server Hardware Requirements


Multiexcerpt
MultiExcerptNameSBC SWe for VMware – Server Hardware Requirements

The following table lists the server hardware requirements:

Caption
0Table
1Server Hardware Requirements



 ConfigurationRequirement
Processor

Intel Xeon processors (Nehalem micro-architecture or above) with 6 cores and above (processors should support hyper threading).

Info
titleNote

Ribbon recommends using Westmere (or newer) processors for better SRTP performance. These processors have the AES-NI instruction set for performing cryptographic operations in hardware.


Info
titleNote

The supported CPU Family number is 6 and CPU Model number must be newer than 26. Refer to the Intel Architecture and Processor Identification document for more information.


Info
titleNote

ESXi 6.5 and later releases require approximately 2 physical cores to be set aside for hypervisor functionality. The number of VMs which can be hosted on a server must be planned for accordingly.


 RAMMinimum 24 GB
Hard DiskMinimum 500 GB
Network Interface Cards (NICs)

Minimum 4 NICs, if physical NIC redundancy is not required.

Info
titleNote

Make sure NICs have multi-queue support which enhances network performance by allowing RX and TX queues to scale with the number of CPUs on multi-processor systems.


Info
titleNote
  • The following NICs are supported for configuring as SR-IOV and DirectPath I/O pass-through devices. SR-IOV is supported only with 10 Gbps interfaces (x540/82599/x710):

Intel I350, x540, x550, x710 and 82599, Mellanox Connect - 4x, and Mellanox Connect - 5x, and CISCO VIC. 

  • The VMware Enterprise Plus license is required for SR-IOV.


Ports

Number of ports allowed:



Warning
titleWarning

The 

Spacevars
0product2
software only runs on platforms using Intel processors. Platforms using AMD processors are not supported.




Multiexcerpt
MultiExcerptNameSBC SWe for VMware – Software Requirements

SBC SWe for VMware – Software Requirements

The following are the

Spacevars
0product2
 requirements for VMware ESXi environments:

VMware ESXi Requirements

Caption
0Table
1VMWare ESXi Requirements


SoftwareVersionTested and Qualified VersionFor More Information
vSphere ESXi 6.0 or above
  • VMware 6.0 tested with VM version 11
  • VMware 6.5 tested with VM version 13
  • Customized ESXi images for various server platforms are available on VMware and hardware platform vendor sites.
    • These ensure that all the required drivers for network and storage controllers are available to run ESXi server.
    • Most of the customized ESXi images come with customized management software to manage the server running the ESXi software.
    • Customized ESXi images for HP ProLiant and IBM servers are available at:
vSphere Client5.1 or above
VMware Knowledge Base
vCenter Server5.1 or above
vCenter Server



Info
titleNote

The VMware Enterprise Plus license is required for SR-IOV.


Third-Party References:


Pagebreak