Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Note

If you configure TLS and downgrade the system to a release prior to Release 7.0, the Exchange CA Certificate for TLS will be unavailable; you must re-deploy or upgrade to Release 7.0. Along with TLS configuration on the CCE, the TLS capability requires a loaded Root CA certificate and a signed certificate on the SBC.

Note

Any changes to the Configure CCE tab requires the CCE to be redeployed.

StepAction
1Login to the WebUI of the SBC Edge.
2Navigate to Tasks  > Office 365 Cloud Connector Edition> Setup.
3Click the Configure CCE tab.
4

Configure all necessary information and then click OK.

Note

TLS 1.2 is supported; the following fields are required to configure TLS:

  • Primary SBC Transport Protocol. Options: TCP or TLS (supports TLS 1.2).
  • Secondary SBC Transport Protocol (optional). Options: TCP or TLS (supports TLS 1.2).

If TLS is configured as the Primary SBC Transport Protocol, you must run the Synchronize CCE/SBC CA Certificate task to allow a successful TLS handshake between CCE and SBC Edge. However, if TCP is configured as the Primary SBC Transport Protocol the Synchronize CCE/SBC CA Certificate task is not mandatory. See Managing Cloud Connector Edition Private Certificates.

Caption
0Figure
1Configuring the ASM – CCE-1

Caption
0Figure
1Configuring the ASM – CCE-2

 

Note: Enterthe ASM's IP address in the HA Master IP Address field. The Slave uses the same root certification as the Master, and this location contains the shared folder that contains the Root CA of the Master.

5

To increase Fast Failover (which shortens the time where certain ported numbers have a long delay from ITSP PSTN provider) configure Trunk Information:

Refer Support. Indicates whether Gateways support Refer for a Call Transfer scenario. Valid entries: Enable (the Gateway(s) supports Refer which can handle call transfer) or Disable (the Gateway does not support Refer and the Mediation Server handles call transfer).

Fast Failover Timer. Determines whether outbound calls that are not answered by the gateway within ten seconds will be routed to the next available trunk; if there are no additional trunks, the call will automatically be dropped. Valid entries: Enable or Disable.

Forward Call History. Indicates whether call history information is forwarded through the trunk. Valid entries: Enable or Disable.

Forward PAI. Indicates whether the P-Asserted-Identity (PAI) header will be forwarded along with the call. Valid entries: Enable or Disable.

6After receiving the activity status as successfully completed, click the Prepare CCE tab to continue.

...