Versions Compared

Old Version 7

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Add_workflow_for_techpubsAUTH1sbsarkarREV5bscogginsREV6bscogginsREV3areddyREV1agogateREV2
Panel

In this section:

Table of Contents

This section describes which SIP headers to use when determining the Calling Party information.

To View and Edit Calling Party

On the SBC main screen, go to Configuration > System Provisioning > Category: Trunk Provisioning > Trunk Group > SIP Trunk Group > Signaling > Calling Party.

Excerpt

The Calling Party window is displayed.

Use the drop-down box to select the desired Address Context, Zone, and SIP Trunk Group.

The Edit Calling Party window is displayed.

Caption
0Figure
1Sip Trunk Group - Signaling - Calling Party

 

The following fields are displayed:

Caption
0Table
1Sip Trunk Group - Signaling - Calling Party parameters

Parameter

Description

Pai For Calling Party

If enabled, the PAI header (if present) will be accepted to form the Calling-Party-ID.

  • Disabled
  • Enabled (default)

Ppi For Calling Party

If enabled, the PPI header (if present) will be accepted to form the Calling-Party-ID.

  • Disabled
  • Enabled (default)

Rpi For Calling Party

If enabled, the RPI header (if present) will be accepted to form the Calling-Party-ID. 

  • Disabled 

  • Enabled (default)

NOTE: Both Ppi For Calling Party and Rpi For Calling Party options are not applicable in Q.1912.5 SIP-I to SIP-I scenarios. Based on the Q.1912.5 recommendation, the mapping to calling party number only occurs if a PAI header containing valid address digits (0-9) are received.

From Hdr For Calling Party

If enabled, the FROM header will be used to form the Calling-Party-ID provided no allowed PAI/PPI/RPI header is present.

  • Disabled
  • Enabled (default)
Map ISUP Cgpn To PAI

When enabled, the SBC maps the ISUP Calling Party Number to SIP From and PAI Headers.

  • Disabled (default)
  • Enabled

For more information, refer to SIP-I Support.

Map From Header To ISUP GAP

When enabled, the SBC maps the From header to ISUP GAP parameters.

  • Disabled (default)
  • Enabled

For more information, refer to SIP-I Support.

Cpc Param From Header

Specifies the SIP Mapping CPC parameter from incoming call to outgoing Trunk Group call.

  • Default (default)
  • Fromheader
  • Paitel

Trusted Source For Isup

Used to indicate if the message came from a trusted source and the FROM header can be used to map into ISUP parameters.

  • Disabled
  • Enabled (default)

 

Make  changes and click Save to save the changes, or Clear to cancel the changes.

Pagebreak