Versions Compared

Old Version 4

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 5

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_workflow_for_techpubs
AUTH1
REV5
REV6
REV3
REV1
 

Use this command to configure Gateway signaling ports for a specified zone. For additional routing details, see Routing Mechanisms page.

...

Code Block
languagenone
% set addressContext <addressContext_name> zone <zone_name> gwSigPort <#>
ipVar <IP Var>
ipAddress <IP address>
ipInterfaceGroupName <name>
mode <inService | outOfService>
portNumber <#>
role <primary | secondary>
state <disabled | enabled>

...

Code Block
languagenone
ipAddress <ip address>
mode <outOfService | inService>
role <primary | secondary>
state <disabled | enabled> enabled> 
ipVar <IP Var>

Command Parameters

Caption
0Table
1Zone Gateway Signaling Port Parameters
 

Parameter

Length/Range

Description

zone

1-23 characters

The name of the zone. For GW-to-GW calls, zone must be “defaultSigZone”.

You can configure signaling, media, and control for a zone in the address context.

Note
Zone name must be unique across all address contexts

.

gwSigPort

1-2048

Gateway (GW) signaling   ports for this zone. Enter an index number for this port, and select parameters:

  •   ipAddress – IP Address of the Gateway Signal Listen Port, either in IPv4 or IPv6 format.
Note
An IPv4-mapped IPv6 address is not allowed.
  • ipInterfaceGroupName – Name of IP interface group used by this gateway signaling port.
  • mode – The operational mode for this gateway signaling port.
    • inService (default)
    • outOfService
  • portNumber – TCP Port number of gateway signaling port
      (default = 2569).
  • role – Role of the gateway signal listening port.
    • primary – (default) Create a listening port for Gateway signaling traffic.
    • secondary – An alternate port used for listening only and cannot be used to establish new gateway signal links.
  • state – Administrative state of gateway listening port.  
    • disabled (default)
    • enabled
  • ipVar – Metavariable name associated with the gateway signaling port IP address. This is used to configure gateway signaling IP address in SBC SWe Cloud.

 

CLI Example

 

To configure MCS Signaling Gateway on I-SBC and D-SBC, execute the command:

Code Block
set addressContext default zone defaultSigZone id 1 gwSigPort 1 ipVar IF2.IPV4 portNumber 2569 ipInterfaceGroupName LIG1 mode inService role primary state enabled
commit
set addressContext default zone defaultSigZone gwTrunkGroup GATEWAY_TG media mediaIpInterfaceGroupName LIG1
commit 
set addressContext default zone defaultSigZone gwTrunkGroup GATEWAY_TG state enabled mode inService ingressIpPrefix 10.34.0.0 16
commit