As an alternative to using the default management interface, the SBC supports using an IP address (IPv4 or IPv6) from a packet interface (pkt0
or pkt1
) for intra-cluster Virtual Network Function Component (VNFC) communication in distributed SBC (D-SBC) deployments.
The To use the packet IP interface's UDP ports that are higher than 1023, you must set the baseUdpPort
parameter. By default the SBC uses UDP port number 3057
for intra-cluster VNFC communication. Therefore, when using if you want to use a packet interface for intra-cluster communication, you must set the parameter baseUdpPort
to a value higher than 3057 to avoid a conflict.. This ensures that the traffic on the 3057 port is not considered media traffic and subsequently dropped as rogue media.
Anchor |
---|
| Setting the Base Udp Port value |
---|
| Setting the Base Udp Port value |
---|
|
Setting the Base UDP Port Value
Info |
---|
|
To use packet IP interface's UDP port higher than 1023, it is required to set baseUdpPort parameter. The loadBalancingService intra-cluster communication uses UDP port 3057. |
To set the value of the parameter baseUdpPort
to more than 3057, execute the following command:
Code Block |
---|
set system media mediaPortRange baseUdpPort 3060
commit |
Anchor |
---|
| Configuring the Intra-cluster VNFC Interface |
---|
| Configuring the Intra-cluster VNFC Interface |
---|
|
Configuring the Intra-cluster VNFC Interface
To use a packet interface for intra-cluster VNFC communication, set the parameter type to ip,
and specify a packet interface IP Interface Group and metavariable, as in the following examples:
IPv6 address:
Code Block |
---|
set system clusterAdmin clusterComm type ip addressContext default ipInterfaceGroup LIG2 pktIpVar IF3.IPV6
commit |
IPv4 address:
Code Block |
---|
set system clusterAdmin clusterComm type ip addressContext default ipInterfaceGroup LIG2 pktIpVar IF3.IPV4
commit |
To use a management interface for intra-cluster VNFC communication, set the parameter type to mgmt
,
and specify a management interface IP Interface Group and metavariable, as in the following examples:
IPv6 address:
Code Block |
---|
set system clusterAdmin clusterComm type mgmt addressContext default ipInterfaceGroup LIG2 mgmtIpVar IF0.IPV6
commit |
IPv4 address:
Code Block |
---|
set system clusterAdmin clusterComm type mgmt addressContext default ipInterfaceGroup LIG2 mgmtIpVar IF0.IPV4
commit |
Include Page |
---|
| Configure_ClusterAdmin_first |
---|
| Configure_ClusterAdmin_first |
---|
|
Refer to D-SBC Signaling Port - CLI, Load Balancing Service - CLI, and DNS Group - CLI for more information.