Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 3

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Caption
0Table
1Call Data Channel Parameters

Parameter

Description

Name

Specifies the name of the IP interface group used to stream to the LI Server.

Pri State

Specifies if the communication to the primary LI Server is enabled or not. Options are:

  • enabled
  • disabled (default)

Sec State

Specifies if the communication to secondary LI Server is enabled or not. Options are:

  • enabled
  • disabled (default)

Pri Mode

Specifies the mode of the primary server. Options are:

  • active
  • standby
  • out of service (default)

Sec Mode

Specifies the mode of the secondary server. Options are:

  • active
  • standby
  • out of service (default)

Pri IP Address

Specifies the primary LI Server's IP address where Call Data Channel messages are sent. Default - 0.0.0.0

Sec IP Address

Specifies the secondary LI Server's IP address where Call Data Channel messages are sent. Default - 0.0.0.0

Pri Port

Specifies the primary LI Server's UDP port where Call Data Channel messages are sent. Default - 0

Ka Timer

Specifies the Keep Alive Timer in seconds. Default - 5

Retries

Specifies the number of retries before LI Call Data Channel is considered failed. Default - 3

IP Interface Group Name

Specifies the name of the IP interface group used to stream to the LI Server.

Li Pol Dip For Regd Ood Msg

Specifies that the policy dip to PSX for the Out-Of-Dialog messages of the registered user is enabled or not. Options are:

  • Enabled
  • Disabled (default)
Dsr TCP PortThe TCP port of the LI server where DSR messages are sent. This value is set when Media Type Intercepted is set to Multimedia. Default - 0
Media Type Intercepted

Specifies the media type interception. Options are:

  • Default  (default) Default
  • Multimedia - When set to multimedia, SBC supports interception of media (audio, fax, clearmode) streams in Encapsulation mode. It also supports the Direct Signaling Report (DSR) messages. DSR messages are signaling messages generated by SBC, when a call is intercepted. The DSR message contains the extra information in the header along with the actual signaling message PDUs.

...