Page History

...

1. Login to SBC BMC using the IP address configured in the previous section. At the prompt, enter:
   Username: root
   Password: superuser
   The SBC BMC main screen appears.

   Caption
   0 Figure 1 BMC Main Screen
   Image Modified

   
   
   

2. Click Configuration tab. The Configuration screen displays.

   Caption
   0 Figure 1 Configuration Screen
   Image Removed

   From Options menu, click > Platform Management Network. The Platform Management Network . A warning message appearsSettings options are displayed. However, if the management addresses are not configured (first time installation), a warning message is displayed stating the same and requesting you to add all the required details.

   Caption
   0 Figure 1 Warning Message

3. Click OK. The Platform Management Network Settings screen displaysdisplayed.
   
   

4. Configure the following network settings for both the Management Interface 0 and 1.
   - IPv4 Address or/and IPv6 Address
   - Prefix
   - Default Gateway

   Click Save.

   Image Removed

   Caption
   0 Figure 1 Platform Management Network Settings
   Image Added

5. Click Save.

   Note
   When upgrading from an application software release prior to SBC 3.1.x, an IPv4-mapped IPv6 address is applied as an unusable placeholder in the IPv6 management address. This mapped address must be removed or set to a valid IPv6 address when updating the management addresses via BMC.

   Note
   If you update the Management IP address through BMC and click Save, you must reinstall the SBC application software. If you update the management IP using CLI, EMS or EMA, it is automatically updated in the BMC and re-installation is not required.

   Caption
   0 Figure 1 Warning Message

   
   
   

...