Use this command to configure Gateway signaling ports for a specified zone. For additional routing details, see Routing Mechanisms page.
...
Parameter | Length/Range | Description |
|---|
zone
| 1-23 characters | The name of the zone. For GW-to-GW calls, zone must be “defaultSigZone”. You can configure signaling, media, and control for a zone in the address context. | Note |
|---|
| Zone name must be unique across all address contexts |
. |
gwSigPort
| 1-2048 | Gateway (GW) signaling ports for this zone. Enter an index number for this port, and select parameters: -
ipAddress – IP Address of the Gateway Signal Listen Port, either in IPv4 or IPv6 format.
| Note |
|---|
| An IPv4-mapped IPv6 address is not allowed. |
ipInterfaceGroupName – Name of IP interface group used by this gateway signaling port. mode – The operational mode for this gateway signaling port.inService (default)outOfService
portNumber – TCP Port number of gateway signaling port
(default = 2569).role – Role of the gateway signal listening port.primary – (default) Create a listening port for Gateway signaling traffic.secondary – An alternate port used for listening only and cannot be used to establish new gateway signal links.
state – Administrative state of gateway listening port. disabled (default)enabled
|