Versions Compared

Old Version 4

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 5

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: formatting

 

 

Use this object to configure various metrics/parameters related to Call Admission Controls on the egress legUse the Egress window to configure egress-specific call admission control (CAC) parameters for all peers using the selected gateway (GW)  trunk group.

On the SBC main screen, navigate to All > Address Context > Zone > Gw GW Trunk Group > CAC > Egress.

The Egress window is displayed. Select the Address Context, Zone and GW Trunk Group from the drop-down lists. The Edit Egress panel opens.

Caption
0Figure
1Egress - Edit Egress

Image Modified

  • Select Address Context, Zone and Gw Trunk Group from their respective drop-down lists.
  • The Edit Egress window is displayed.
  • Make necessary changes and click Save. Click Clear to cancel the changes.

    •  

    Use the following table to configure the options for the specified GW trunk group and then click Save.The parameters displayed on the Edit Egress window are:

    Caption
    0Table
    1Edit Egress - Parameter Description Table
    ParameterDescription
    Call LimitTotal number of concurrent calls (0-2147483647, or unlimited), allowed on the egress leg. (default=unlimited)
    Emergency OversubscriptionThe percentage (0-1000) of resource oversubscription allowed for emergency calls. (default=10)
    Hpc OversubscriptionThis parameter specifies the amount of resource over-subscription (0-100), as a percentage, that are allowed for HPC. When the baseline call limit and bandwidth limit are reached, normal calls are not admitted, but additional HPC are allowed up to the configured percentage value. (default=10)
    Call Rate Max

    Maximum sustained egress call rate (SBC 5000: 1-450, or unlimited; SBC 7000: 1-1350, or unlimited) allowed in calls per second. (default=unlimited)

    Call Burst Max

    Maximum allowed burst size (SBC 5000: 1-900, or unlimited; SBC 7000: 1-2700, or unlimited) above the allowed sustained rate for egress call attempts, in calls per second. (default=unlimited)

    Note: You can set both Call Burst Max and Call Rate Max as unlimited; however, if you assign a value to one parameter, the other must also be assigned a value.

    Info
    titleNote

    Call policing, using Call Rate Max and Call Burst Max, is applicable only to normal and emergency calls, and not to high priority calls (HPC).

     

    Pagebreak