| Add_workflow_for_techpubs |
|---|
| AUTH1 | eyoustra |
|---|
| REV5 | bscoggins |
|---|
| REV6 | bscoggins |
|---|
| REV3 | |
|---|
| REV1 | rramaiah |
|---|
|
Use this window to specify SBC handling when modem tones are
...
detected.
To View and Edit Modem Options
On the
main screen, go to Configuration > Profile Management > Category: Media Profiles > Codec Entry >Modem. The Modem window is displayed.Select the desired Codec Entry from the drop-down list to view its respective
...
modem parameters.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Profile Management - Media Profiles - Codec Entry - Modem |
|---|
|
 Image Modified
|
...
Use the following table to configure the options and then click Save.
| Caption |
|---|
| 0 | Table |
|---|
| 1 | Codec Entry - Modem Parameters |
|---|
|
|
...
Failure Handling | Specifies the behavior when a modem tone is detected but the treatment fails for any reason. The behavior can be: - Disconnect—Release the call.
- Continue (default)—Continue to process the call.
|
|
...
| Tone Treatment | Specifies the treatment taken when |
|
...
...
tones are detected, which can be: |
|
...
- None (default)—Do nothing when
|
|
...
...
...
- Notify Peer—Notify the peer when
|
|
...
...
...
- Disconnect—Disconnect the call when
|
|
...
...
...
- Fallback To G711—Fall back to G.711 when
|
|
...
...
...
- Apply Fax Treatment—Treat the modem tone as a fax tone, and apply the fax treatment for the selected codec.
|
|
...
The default setting is None.
| | Honor Tone Detection | Enable this option for G.711 to G.711 transcoded calls to cause the SBC to initiate a re-invite upon modem tone detection when the modem Tone Treatment configuration is Fallback To G711. When disabled, the SBC ignores the modem tone. This option only applies to a G.711 codec without silence suppression. |
|
...
|
|---|
|
For G.711 calls, Notify Peer and Disconnect require a compression resource to be allocated. |
...