Versions Compared

Old Version 19

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_docset_workflow
AUTH1UserResourceIdentifier{userKey=8a00a0c85b2726c2015b58aa779d0003, userName='null'}
DEV1UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26ca91048d, userName='null'}
LDEV1UserResourceIdentifier{userKey=8a00a0c85b2726c2015b58aa779d0003, userName='null'}
SVT1UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26ccd308e6, userName='null'}
LSVT1UserResourceIdentifier{userKey=8a00a0c85b2726c2015b58aa779d0003, userName='null'}
AUTHJIDSYM-27561

 

CSS Stylesheet
img.confluence-embedded-image { display: inline-block !important; }

...

Caption
0Table
1Port and Protocol Panel - Field Descriptions
3Port and Protocol Panel - Field Descriptions
FieldDescription
Port NameSpecifies the physical T1/E1 port used for this Signaling Group.
FractionalSpecifies whether or not the port is fractional. If selected, you must add a list of channels.
Channel List SelectionSpecifies to which channels the Signaling Group is applied if the port is fractional.
Switch VariantSpecifies the ISDN variant for this signaling group.
ISDN Side

Specifies the ISDN user/network side for this signaling group .

Play Ringback

Specifies when to generate local ring back:

  • Auto on Alert. Generates Ringback on Alert message. Depends if inband audio is available.
  • Auto On Alert/Progress  Generates Ringback on Alert/Progress message. Depends if inband audio is available.
  • Always on Alert. Always generates inband ringback on Alert message.
  • Always on Alert/Progress: Always generates inband ringback on Alert/Progress message.
  • Never: Never generate inband ringback.
Service Msg CapabilitySpecifies whether service messaging is used on the signaling group. Valid only for ATT 4ESS, ATT 5ESS, NI2 and Japanese ISDN Switch Variants.
Overlap Receive Mode

Specifies if received overlap dialing is enabled on the signaling group. Valid only for Euro ISDN (ETSI) and QSIG Switch Variants.

Note: To route Calls faster: If you are not using Overlap dialing, you can turn off Overlap Receive Mode to remove any time the SBC waits before routing the call, or lower the T302 timer to route the call faster.

Overlap Receive ModeSpecifies whether or not overlap sending is enabled. Overlap sending is not executed if an ActionSet is configured for the inbound Signaling Group of if Fork Call is set to Yes in the call route. Valid only when QSIG or Euro ISDN is the value of the Switch Variant field.

...