Page History
...
- In the WebUI, click the Settings tab.
- In the left navigation page, access SIP > SIP Profiles.
Click the (
) icon at the top of left corner and add a new SIP profile.Configure the parameters as shown below (example values are shown in the table; configure as per your network requirements). For details on field descriptions, refer to Creating and Modifying SIP Profiles.
Leave all other parameters as default.
Click OK.
Caption 0 Table 1 SIP Profile Configuration - Example Values Parameter
Example Value
Description
Teams Direct Routing Profile
FQDN in From Header
SBC Edge FQDN
FQDN In Contact Header
SBC FQDN
NOTE: For Microsoft Teams, the Signaling Group facing the Teams server must be configured as SBC Edge FQDN or Static (if there is more than one signaling group connected to Teams Direct Routing). The FQDN in Contact Header should be the same FQDN used in Office 365 Tenant Online Gateway. If the IP Address of the SBC is configured in the Contact Header instead of the FQDN of the SBC, a Forbidden message is received.
NOTE: If you set this field to Static and you expect the port number of the Contact header in the outbound SIP messages, you must configure the Static Host FQDN/IP field with the Listen Port number of the SIP signaling group.
Origin Field Username
<FQDN of SBC> (in the example aepsite6.SonusMS01.com)
Available_since Type Modified For Release 8.0.2 Pagebreak Caption 0 Figure 1 SIP Profile - Example 
...
- In the WebUI, click the Settings tab.
- In the left navigation page, access SIP > SIP Profiles.
Click the (
) icon at the top of left corner and add a new SIP profile.Configure the parameters as shown below (example values are shown in the table; configure as per your network requirements). For details on field descriptions, refer to Creating and Modifying SIP Profiles.
Leave all other parameters as default.
Click OK.
Caption 0 Table 1 SIP Profile Configuration - Example Values Parameter
Example Value
Description
SIP Trunk Profile
FQDN in From Header
Disable
FQDN In Contact Header
Disable
NOTE: If you set this field to Static and you expect the port number of the Contact header in the outbound SIP messages, you must configure the Static Host FQDN/IP field with the Listen Port number of the SIP signaling group.Origin Field Username SBC Available_since Type Modified For Release 8.0.2 Caption 0 Figure 1 SIP Profile - Example 
...
Overview
Content Tools