...
Access the WebUI. Refer to Logging into the SBC Edge.
Configure TLS Profile
The TLS profile defines the crypto parameters for the SIP protocol; it is used as the transport type for incoming and outgoing SIP trunks.
...
- In the WebUI, click the Settings tab.
- In the left navigation page, access Signaling Groups
From the Create Signaling Group drop down box, select SIP Signaling Group.
- Configure the parameters as shown below. Leave the default values for all other parameters.
Click OK.
Caption |
---|
0 | Table |
---|
1 | Signaling Group Configuration - Example Values |
---|
|
Parameter | Value |
---|
Description | From Microsoft Teams | SIP Profile | Teams Direct Routing Profile | Media List ID | Team Direct Routing List | Signaling Media/Private IP
| Ethernet 1 (example, choose the interface which faces Microsoft Teams Direct Routing) | Listen Port | 5061 TLS | Federated IP/FQDN | sip-all.pstnhub.microsoft.com | SIP server table | Teams Direct Routing Server | Load Balancing | Priority: Register All | SIP Profile | Microsoft Phone System (from previous step) | Call Routing Table | Default | Outbound NAT | traversalTraversal* | Static NAT | NAT Public IP* | IP Address (Only required if “Static NAT” is selected) | Static NAT Inbound | Disabled (this field should not be configured for Non-Media Bypass Teams deployment) |
*Outbound NAT Traversal and the NAT Public IP is required when the SBC is behind a NAT (the public IP address of the NAT device is required when the SBC has a Private IP). |
Caption |
---|
0 | Figure |
---|
1 | Signaling Group - Example |
---|
|
|
...
- In the WebUI, click the Settings tab.
- In the left navigation page, access Signaling Groups
From the Create Signaling Group drop down box, select SIP Signaling Group.
Configure the parameters as shown below. Leave the default values for all other parameters.
Click OK.
Caption |
---|
0 | Table |
---|
1 | Signaling Group Configuration - Example Values |
---|
|
Parameter | Value |
---|
Description | From SIP Trunk | SIP Profile | SIP Trunk | Media List ID | SIP Trunk List | Signaling Media/Source IP | Ethernet 2 (example, choose the interface which faces the SIP Trunk) | Listen Port | 5060 UDP | Federated IP/FQDN | IP Address | SIP Server table | SIP Trunk Server | Load Balancing | Round Robin | SIP Profile | SIP Trunk | Call Routing Table | Default | Outbound NAT | traversalTraversal* | None | NAT Public IP* | IP Address (Only required if “Static NAT” is selected) | Static NAT Inbound | Disabled (this field should not be configured for Non-Media Bypass Teams deployment) |
*Outbound NAT Traversal and the NAT Public IP is required when the SBC is behind a NAT (the public IP address of the NAT device is required when the SBC has a Private IP). |
Caption |
---|
0 | Figure |
---|
1 | Signaling Group - Example |
---|
|
|
...