Page History

...

1. In the WebUI, click the Settings tab.
2. In the left navigation page, access Signaling Groups
   

3. From the Create Signaling Group drop down box, select SIP Signaling Group.

4. Configure the parameters as shown below. Leave the default values for all other parameters.

5. Click OK.

   Caption
   0 Table 1 Signaling Group Configuration - Example Values
   Parameter Value RTCP Multiplexing Enable ICE Support Enabled ICE Mode Lite Outbound NAT Traversal* Static NAT NAT Public IP (Signaling/Media)* Public Address for the NAT device assigned on the media port for your network Static NAT Inbound Disabled (this field should not be configured for Media Bypass Teams deployment) *Outbound NAT Traversal and the NAT Public IP is required when the SBC is behind a NAT (the pubic public IP address of the NAT device is required when the SBC has a Private IP).

   Note
   The peer endpoint must support the a=rtcp-mux exchange in order for the RTP and RTCP ports to be multiplexed into one data port.

   Pagebreak

   Caption
   0 Figure 1 SIP Signaling Group - Example