Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

This section specifies the R-Factor signaling quality measurement.

To View and Edit

...

QOE - Rfactor

On SBC main the

Spacevars
0product
 main screen, go to Configuration > System Provisioning > Category: Trunk Provisioning > Trunk Group > Sip Trunk Group > Sip Trunk Advanced > Qoe > QOE > Rfactor. The Rfactor window is displayed.

The Qoe QOE - Rfactor can be checked for each Address Context, for each Zone, for each Sip SIP Trunk Group created or for all the Address Contexts, Zones and Sip SIP Trunk Groups created. Use the drop-down box to select the desired Address Context, Zone and Sip SIP Trunk Group.

The Edit Rfactor window is displayed.

Caption
0Figure
1Sip Trunk Advanced - Qoe QOE - Rfactor Edit Window

The following fields are displayed:

Caption
0Table
1Sip Trunk Advanced - Qoe QOE - Rfactor Parameters


Parameter


Description

Critical Qos RFactor LimitSpecifies the critical R-Factor limit, below which the call admission should be stopped. The value range from 0 - 100 and the , with a default value is of 50.
Major Qos RFactor LimitSpecifies the major R-Factor limit, below which the call admission should be reduced. The value range from 0 - 100 and the , with a default value is of 70.

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

...