This object is used to configure sender report intervalUse the Media RTCP Control window to configure RTCP session parameters for the system.
On the SBC main screen, go to All > System >Media > Media Rtcp RTCP Control. The Media Rtcp Control RTCP Control window is displayedopens.
Caption |
---|
0 | Figure |
---|
1 | System - Media - Media Rtcp Control |
---|
|
Image Modified |
The following fields are displayed:Use the following table to configure the options and then click Save.
Caption |
---|
0 | Table |
---|
1 | Media RTCP Control Parameters |
---|
|
Parameter | Description |
---|
Sender Report Interval | Specifies the RTCP SR (sender report) interval when RTCP is terminated by NP. | When RTCP termination is enabled in the Packet Service Profile, this value specifies the initial interval for generating the sender/receiver report. The allowed range is between 5 and 120 seconds. The default value is 5. | Send BYEPacket | When RTCP termination is enabled in the Packet Service Profile, this option specifies | Send BYEPacket | Use this flag to choose whether or not to send RTCP BYE packet.packets when calls are terminated. The options are: - Disabled
disabled – Use this setting to suppress RTCP BYE packet packets in a pass-through scenario scenarios when the RTCP terminationForPassthrough option is enabled and the call is not established. This setting is useful to avoid one-way audio when Dynamic LRBT and RTCP are in use at the same time. enabled Enabled (default) – When this flag is enabled, the SBC sends the an RTCP BYE packet when a call is terminated. This command setting affects all calls configured with RTCP termination.
|
|
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.