...
Enter and select the desired configuration details in the Create New Bfd panel. Click Save.
| Caption |
|---|
| 0 | Table |
|---|
| 1 | Bfd Screen Parameters |
|---|
|
| Parameter | Description |
|---|
| Name | The BFD session name. | | State | Use this flag to enable or disable the administrative state of the BFD session. - Disabled (default) - You can configure the BFD parameters.
- Enabled - You cannot configure the BFD parameters.
| | Remote IP | Configure this parameter with the IP address of the remote node. The IP address is usually on packet interfaces for signaling and media. | | Remote Port | Configure this parameter with the remote port of the BFD session. The default value is 3784. | | Desired Min Tx Interval | Configure this parameter with the desired minimum (in seconds) of the transmitted interval. The default value is 1. | | Required Min Rx Interval | Configure this parameter with the required minimum (in seconds) of the received interval. The default value is 1. | | CE Name | The current element name (optional). You can configure this parameter when the BFD session for active and standby are on different networks. If you do not configure this parameter, the creates the BFD session on both the active and standby nodes, but the BFD packets transmit from only the active node. This packet behavior means that the BFD session is up on the active node after a switchover. |
|
| Info |
|---|
|
You can only modify the bfd Bfd parameters (except the CE Name) when the bfd BFD State is disabled. To modify the CE Name, you must delete and then recreate the BFD session. |
...