...
...
| borderColor | green |
|---|
| bgColor | transparent |
|---|
| borderWidth | 2 |
|---|
...
Back to Table of Contents
Back to CLI Configure Mode
Back to Address Context - CLI
Static IP Routes for IP Interfaces
The staticRoute object is used to configure static IP routes for the IP interfaces. A static route indicates the nextHop gateway and IP interface that is used for a particular peer network IP prefix.
A route preference may be configured for static routes as shown in the command syntax. The lower the preference value, the more likely the route is to be used.
| Include Page |
|---|
| IP_IGs_ServedBySeperateProcessors |
|---|
| IP_IGs_ServedBySeperateProcessors |
|---|
|
Command Syntax
| Code Block |
|---|
|
% set addressContext <addressContext_name> staticRoute <destinationIpAddress> <ip_prefix_length> <nextHopIPaddress> <ipInterfaceGroupName> <ipInterfaceName> preference <preferenceNumber>
% show addressContext <addressContext_name> staticRoute
% delete addressContext <addressContext> staticRoute <IpAddress> |
Command Parameters
| Caption |
|---|
| 0 | Table |
|---|
| 1 | Static Route Parameters |
|---|
|
Parameter | Length/Range | Description |
|---|
addressContext
| 1-23 | <addressContext_name> – The name of the address context. The address context is a container of objects that correspond to a specific IP Addressing domain.
| staticRoute
| N/A | <destinationIpAddress> – The destination IP address. The following IP address types are supported:
- IPv4 – This is V4 IP address in dotted decimal form (for example 128.127.50.224).
- IPv6 – This is V6 IP address in hexadecimal/colon form (for example, 1280:1276:3350:2224:2222:3333:8888:1245 or fd00:21:445:128::7880).
| <ip_prefix_length>
| N/A | The IP prefix length of this static route entry. | <nextHopIPaddress>
| N/A | The IPv4 or IPv6 address of the next system en route to the destination. | <ipInterfaceGroupName>
| N/A | The name of the IP interface group. | <ipInterfaceName>
| N/A | The name of the IP interface for this entry. | preference
| N/A | <preferenceNumber> – The route preference value. The management route preference range is 1-99 and the packet route preference range is greater than or equal to 100.
| displaylevel
| 1-64 | To display different levels of output information in show commands. |
|
Command Example
To display static routes:
| Code Block |
|---|
|
% show addressContext default staticRoute
staticRoute 10.6.30.105 32 10.34.26.1 LIF2 lif_eth3 {
preference 10;
}
staticRoute 10.34.9.70 32 10.34.25.1 LIF1 lif_eth2 {
preference 10;
}
staticRoute 10.34.9.95 32 10.34.26.1 LIF2 lif_eth3 {
preference 10;
}
staticRoute 10.34.13.194 32 10.34.25.1 LIF1 lif_eth2 {
preference 1;
}
staticRoute 10.34.13.195 32 10.34.26.1 LIF2 lif_eth3 {
preference 10; |
The staticRoute object is used to configure static IP routes for the management interfaces. A static route indicates the nextHop gateway and management interface that is used for a particular peer network IP prefix.
| Info |
|---|
| For details on Static IP Routes for Management interfaces, |
...