the
main screen, navigate to All > Address Context > Diam Node.The Diam Node can be checked for each Address Context or for all the Address Contexts created. Use the drop-down box to select the desired Address Context.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | All - Address Context - Diam Node Main Field |
|---|
|
 Image Modified
|
The Diam Node window is displayed.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | All - Address Context - Diam Node |
|---|
|
Image Modified |
To Edit Diam Node
To edit any of the Diam Node in the list, click the radio button next to the specific Diam Node name.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | All - Address Context - Diam Node Highlighted |
|---|
|
Image Modified |
The Edit Selected Diam Node window is displayed below.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | All - Address Context - Diam Node Edit Window |
|---|
|
Image Modified |
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.
To Create Diam Node
To create a new Diam Node, click New Diam Node tab on the Diam Node List panel.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | All - Address Context - Diam Node Fields |
|---|
|
Image Modified |
The Create New Diam Node window is displayed.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | All - Address Context - Diam Node Create Window |
|---|
|
Image Modified |
The following fields are displayed:
| Caption |
|---|
| 0 | Table |
|---|
| 1 | Diam Node Parameters |
|---|
|
Parameter
|
Description
|
|---|
Name | Specifies the name of this Diameter Node. The value ranges up to 23 characters. | Origin Realm | Specifies the description of the origin realm of this node. The value ranges up to 128 characters. | Primary Origin
Host | Specifies the description of the primary origin of this node. The value ranges up to 128 characters. | Secondary
Origin Host | Specifies the description of the secondary origin of this node. The value ranges up to 128 characters. | Transaction
Timeout | Specifies the time out value in milli seconds. The value ranges from 500 to 6000 and the default value is 1000. | State | Specifies the state of the Diameter Node. The options are: enableddisabled (default)
| Dump Pdu | When enabled, SBC logs the DIAMETER PDU sent and received on the Rx interface to the debug log. The options are: enableddisabled (default)
| IP Interface
Group Name | Specifies the name of the IP Interface group used by this node. | IP V4Address | Specifies the IPv4 address used to create connections towards peer. | IP V6Address | Specifies the IPv6 address used to create connections towards peer. |
|
To Delete Diam Node
To delete any of the created Diam Node, click the radio button next to the specific Diam Node which you want to delete.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | All - Address Context - Diam Node Highlighted |
|---|
|
Image Modified |
Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | All - Address Context - Diam Node Delete Confirmation |
|---|
|
Image Modified |
Click Yes to remove the specific Diam Node from the list.