Page History

...

1. Log on to the EMS.

2. In Network Management pane, click Cluster / VNF Management.
   The Cluster/VNF Management window appears.

   Caption
   0 Figure 1 Cluster/VNF Management Screen

3. In Cluster/VNF Management window, perform the following:

   1. Select the Signaling SBC Cluster from Cluster/VNF List section. The Cluster <name> section appears in the screen.

      Caption
      0 Figure 1 Cluster VNF List

   2. Click Configurations tab from Cluster ssbc section.

      Caption
      0 Figure 1 Configuration Screen

   3. Click New Configuration. The New Configuration section appears in the screen.

      Caption
      0 Figure 1 Creating New Configuration

   4. In New Configuration section, Select Version, Master Configurator from the drop-down menu, and enter Configuration Name.

   5. Click Create.
      The Configurator clears db the database and reboots. The  The Rebooting takes approximately five minutes.

      Caption
      0 Figure 1 Rebooting the Configurator

      Caption
      0 Figure 1 Displaying Open Editor Button

      Note
      The New Configuration section is closed and an Open Editor button appears in the Cluster ssbc section.

   6. Click Open Editor to launch SBC Configuration Manager.

      Caption
      0 Figure 1 Launching SBC Configuration Manager

4. Follow the steps 4a through step 4k to configure SBC parameters using SBC Configuration Manager.
   1. To validate the meta variable table, see Validating the Meta Variable Table.

   2. To create an IP interface group and an IP Interface, see Creating an IP Interface Group and an IP Interface.

   3. To create static route, see Creating Static Route.
   4. To create DNS group and DNS server, see Creating DNS Group and DNS Server.
   5. To create a NTP server, see Creating a NTP Server.
   6. To create D-SBC SigPort, see Creating D-SBC SigPort.
   7. To create a cluster type, see Creating Cluster Type.
   8. To create a zone, see Creating Zone.
   9. To create SIP SigPort, see Creating SIP SigPort.
   10. To create SIP trunk group, see Creating SIP Trunk Group.
   11. To create remote policy server, see Configuring Remote Policy Server.

   12. Click Applied Saved Changes and click Close.

       Caption
       0 Figure 1 Applying Saved Changes

5. In Cluster/VNF Management screen, a new ssbc section appears in the screen.

6. Click Activate Configuration from ssbc section.

   Caption
   0 Figure 1 Activating Configuration

   
   The configuration is successfully activated on SSBC cluster. The Cluster Status displays All nodes online, once the configuration is successfully activated.

   Caption
   0 Figure 1 SSBC Cluster Status Online

...