Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 3

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Noprint
Panel
borderColorgreen
bgColortransparent
borderWidth2

Back to Table of Contents

Back to CLI System-Level Mode

Back to Show Command Details - CLI

Back to show status Command Details

Panel

In this section:

Table of Contents
maxLevel3

Command Syntax

 

Code Block
languagenone
> show status oam
	accounting
		cdrServer status
		radius radiusServerStatus
	alarms
		ethernetCrcErrAlarmStatus
		ipPolicingAlarmStatus
		mediaSrtpErrAlarmStatus
	eventLog
		confdDebugLevel
		filterStatus
		typeStatus
	localAuth userStatus
	snmp community

Command Parameters

Note

The following objects are included in this table for completeness, but only apply when using the  Show Table System command. Additionally, and administrative statistics shown below do not apply to 'show status oam' command.

ema, radiusAuthentication, traps

Multiexcerpt include
MultiExcerptNameOamParams
nopaneltrue
PageWithExcerptShow Table OAM

 

Command Example

 To display status of OAM SNMP objects:

Code Block
languagenone
> show status oam snmp community engineId 
engineId 80:00:0b:3f:03:00:10:6b:02:c7:ef;

To display the status of OAM Eventlog objects:

Code Block
languagenone
> show status oam eventLog typeStatus security 
currentFile 1000006.SEC; 
fileRecords 6; 
fileBytes 986; 
totalFiles 31; 
totalFileBytes 10955; 
memoryRecords 0; 
memoryBytes 0; 
filesDropped 0; 
memoryDropped 0; 
nextRollover 0; 
logDestination localDisk; 
lastFileDrop 0000-00-00T00:00:00Z; 
lastMemoryDrop 0000-00-00T00:00:00Z;

Error Messages

Include Page
NP0_Error_Counter_Message
NP0_Error_Counter_Message