...
Caption | ||||
---|---|---|---|---|
| ||||
|
Probing Mechanism | SBC Platforms | Affected Ports | Purpose | ||||||
---|---|---|---|---|---|---|---|---|---|
Physical link detection | All | All ports on both active and backup CEs |
| ||||||
ICMP ping | All | Active ports only | Checks two-way connectivity between
| ||||||
ARP ACD/ICMPv6 NUD* | SBC 7000 only | Standby ports only | Verifies physical media by checking two-way traffic through at least the local Ethernet interface, the cable, and the adjacent layer 2/3 switching function. Layer 3 verification is accomplished using ARP ACD Probes (for IPv4) or Neighbor Discovery (for IPv6) mechanisms to probe an arbitrary, operator-specified target IP address on a local IP subnet, typically the address of the next-hop router (Gateway IP address). Depending on the address family (IPv4/IPv6) of the gateway IP address configured, either ARP ACD or ICMPv6 NUD probing messages are sent in such a way that explicit assignments of IP addresses to the standby ports are not required. See below for specifics on IPv4 ARP ACD requirements. When IP Target is to 0.0.0.0 and/or “probeOnStandby” is disabled, only the physical link state between active/standby
|
* Address Resolution Protocol - Address Conflict Detection / Internet Control Message Protocol Version 6 – Neighbor Unreachability Detection
...