...
| Caption |
|---|
| 0 | Table |
|---|
| 1 | Path Check Profile Parameter |
|---|
|
| |
Parameter | Length/Range | Description |
|---|
pathCheckProfile
| 1-23 | <profile name> – The name of the Path Check Profile.
|
failureResponseCodes
| 400-699, or
(all, all4xx, all5xx, all6xx) | Use this parameter to define one or more response codes to treat as failure responses. The options include the following: 400-699 – Enter a single code, or enter multiple codes within square brackets and separating each entry with a space. For example, [409 505 699]all – include all response codes from 400-699all4xx – include all 4xx response codesall5xx – include all 5xx response codesall6xx – include all 6xx response codes
| Info |
|---|
When you use more than one value, enclose the values in square brackets [ ], separating each value with a space. Entering a value without using brackets appends the value to the existing configuration. |
| Note |
|---|
Ensure failureResponseCodes values for Path Check Profile and SIP ARS Profile within the same zone/trunk group use similar values to avoid unexpected behavior. For example, it is not advisable to set Path Check Profile failureResponseCode to "all" and SIP ARS Profile failureResponseCodes to "all4xx" and "all6xx". See SIP ARS Profile - CLI.
|
|
protocol
| N/A | The ping protocol type used. |
recoveryCount
| 1-10 | The number of consecutive successful responses to occur before removing the endpoints from the Blacklist. (default = 6) |
replyTimeoutCount
| 1-10 | The number of consecutive timeouts to occur before adding the endpoints to the Blacklist. (default = 6) |
sendInterval
| 1-600 | Specifies interval (in seconds) in which the PING request will be sent out to the endpoints. (default = 60) |
transportPreference | N/A | Transport preference for sending OPTIONS method. preference1 – Default value is sip-udppreference2 – Default value is sip-tcppreference3 – Default value is tls-tcppreference4 – Default value is sctp
| Note |
|---|
Ensure SIP Sig Port transportProtocolsAllowed setting is configured to support the chosen transport preference (see |
|
...
Command Examples
This example creates a patch check profile named "PCP-1" with the default ping protocol type "sipOptions", a recovery count of "7" and a send interval of "120" seconds. The reply timeout count is left at the default of "6". Next, the PCP is assigned to "defaultSigZone" zone for default address context using IP address "10.20.120.21".
...