Page History

...

The following SFP transceivers are compatible with SBC 5400

Spacevars
0 model5

in all Management, Media, and HA ports:

...

SFP transceivers must be installed in the Media, Management and HA (if configured for HA) ports of each SBC 5400 each 

Spacevars
0 model5

server before making the fiber/copper connections.

• Insert the SFP Gigabit Ethernet LC or SFP Gigabit Ethernet copper RJ-45 transceivers into SBC 5400 into 

  Spacevars
  0 model5

  media ports 0-3, as needed.
• Insert the SFP Gigabit Ethernet LC or SFP Gigabit Ethernet copper RJ-45 transceivers into Management ports 0-3.
• Insert the SFP Gigabit Ethernet LC or SFP Gigabit Ethernet copper RJ-45 transceivers into HA ports 0-1, as needed.

...

1. Attach an Electrostatic Discharge (ESD) wrist strap (provided in the SBC 5400 the 

   Spacevars
   0 model5

   kit) using the ESD grounding point on the rear panel of the chassis (see Connecting ESD Wrist Strap). 
2. Insert the Sonus-approved SFP transceiver into the desired socket and ensure that the proper orientation when inserting, and that you will hear a click-in when the SFP is seated correctly.
3. Connect/reconnect the fiber optic and/or CAT 5 cables, as appropriate, to media and HA ports.
4. Verify LEDs above the part are flashing indicating link status and data activity.
5. Verify port functionality using the CLI show status system commands once the SBC application software is installed and the system is up and running (for details, see show status systemfrom the 5.0.x documentation).

   1. Verify management and packet port functionality:

      Code Block
      language none
      > show status system ethernetPort

   2. Verify HA port functionality:

      Code Block
      language none
      > show status system highAvailabilityPort

...

When connecting a serial cable to the rear serial port of the SBC 5400 the 

Spacevars
0 model5

server for communication with a host PC, refer to the figure below for the serial port location.

...

The physical connection between two SBC 5400 two 

Spacevars
0 model5

systems consists of a pair of GigE cables (Use the Single mode or Multi mode fiber optic CAT5e cable (NON-CROSSOVER TYPE ONLY), directly connected between each HA ports.

...

Note
The Alarm port is not supported by the SBC 5400 the  Spacevars 0 model5 application software in this release.

The SBC 5400 The 

Spacevars
0 model5

ports, allow you to sense (Alarm In) and issue (Alarm Out) external signal. The Alarm Port utilizes a HD15 pin connector and supports 4 output alarms and 2 input alarms. You must create the remainder of the cable, wiring the appropriate sensor or alarm leads to the screw terminator on the connector.

...