Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Panel
borderColorgreen
bgColortransparent
borderWidth2
Noprint

Back to Table of Contents

Back to CLI Configure Mode

Back to Profiles - CLI

Additional sections:

Children Display
styleh5

 

The Digit Parameter Handling feature allows you to configure criteria for applying DM/PM (digit manipulation/parameter manipulation) rules. You can also use this entity to define criteria for applying URI manipulation rules.

For digit manipulation, the matching criteria can be digits in the calling or called numbers, out pulse numbers from SCP queries, generic numbers, and so on. For example, you can provision the Policy Server to check if the first three digits of the calling number are 617, or to check if digits 4 through 6 are 723.

For parameter manipulation, the matching criteria is based on the specified parameter type. For example, you can provision the Policy Server to match a specified Calling Party Category (CPC), or match a specified Originating Line Information Parameter (OLIP) value.

There is also a URI parameter type used to match the contents of the specified URI type.

The Digit Parameter Handling high-level syntax is shown below. Each of the objects below is defined on the subsequent pages in this guide.

 

Code Block
languagenone
% set profiles digitParameterHandling 
	dmPmCriteria <dmPmCriteria_id>  
	dmPmRule <dmPmRule_id> 
	numberTranslationCriteria <numberTranslationCriteria> 
	numberingPlan <numberingPlan> 
	prefixProfile <prefixProfile>
Note
iconfalse
titleNote

Only the numberingPlan entity is available from the ERE when the SBC is configured for ePSX.

 

Pagebreak