Page History

...

1. Log on to SBC BMC GUI using the IP address configured in the previous section.

   Code Block
   language none
   username: root password: superuser

   
   The BMC Main Screen appears:

   Caption
   0 Figure 1 BMC Main Screen
   Image Modified

    

2. Click Configuration > Platform Management Network tab. The Platform Management Network Settings screen is displayed.

   Note
   Refer to SBC 5400 Media Ports and Operation Operational Modes to know more about these four media ports and their operational modes.

   Warning
   Any changes to the media port speed, deletes the existing configuration. To use the option, Enable 10G Media Speed, power off the host first.

   The SBC 5400 platform includes the following configurable media port configurations.

   Caption
   0 Table 1 Media Port Configuration Options
   Image Added

   Media Port Speed	Description
   10 Gbps	Pkt0 runs at 10 Gbps Pkt1, Pkt2, and Pkt3 are inactive
   1 Gbps	In 4x1Gbps mode: Pkt0, Pkt1, Pkt2, and Pkt3 run at 1 Gbps and all the four ports are configurable. Pkt2 and Pkt3 ports will not operate without the 4x1Gbps license. In 2x1 Gbps mode: Pkt0 and Pkt1 run at 1 Gbps Pkt2 and Pkt3 are inactive

   Note
   In 10 Gbps mode, only media0 is configurable and operable.

   Note
   2 x 1 Gbps mode is a default mode that any SBC 5400 platform can use. A license is required to use both 4 x 1 Gbps and 1 x 10 Gbps modes. If there is no license, only ports 0 and 1 are operable.

   
   The media port speed is user-configurable and the following licenses are added in this release in support of the media port configurations:

   • SBC-4X1GMP – This license allows four 1 Gbps media ports.
   • SBC-1X10GMP – This license allows one 10 Gbps media port.
     

    

   Caption
   0 Figure 1 BMC Platform Management Network Settings Window

   Image Removed

    

   • 
     

   Note
   A message appears to enter the management IP addresses for the first time installation.

   Caption
   0 Figure 1 BMC PMNS Info Message
   Image Modified

3. Click OK.
4. Configure the following network settings for all the four management interfaces from 0 to 3.
   

   - IPv4 Address or/and IPv6 Address

   - Prefix

   - Default Gateway

   Caption
   0 Figure 1 BMC Platform Management Network Settings Window
   Image Modified

    

5. Click Save.

Caption
0 Figure 1 BMC Warning Message
Image Added

Image Removed