Page History
| Add_workflow_for_techpubs | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Panel | ||||
|---|---|---|---|---|
| ||||
In this section:
|
| Info | ||
|---|---|---|
| ||
Related articles:
|
Overview
| Excerpt Include | ||||||
|---|---|---|---|---|---|---|
|
SNMP Traps
Traps are events reported by the SNMP devices. Some SNMP traps are also alarms, and are displayed on the command line interface of the SBC.
| Note | ||||
|---|---|---|---|---|
| ||||
To configure trapTarget using CLI, refer How to Configure SNMP Trap Targets To configure trap Target using EMA, refer SNMP - Trap Target To configure traps using EMS, refer SNMP Trap Management |
To view the the related alarms, execute the command:
| Code Block |
|---|
show table alarms currentStatus |
To view trap configuration details, refer
Alarms
A trap is considered an alarm when there is a condition that needs attention by the operator. Some alarms are cleared by themselves, such as a port up/down alarm. Other alarms require manual intervention to clear.
Alarms provide alerts/warnings of abnormal activity such as a software failures, system faults, exceptions, hardware issues, and so on. Alarms are primarily viewed using the CLI and EMA interfaces. But some major and critical alarms also have LED indicators on the SBC.
SBC displays alarms according to the following categories:
- Current alarms
- History alarms
Current Alarms
The Current Alarms screen displays the alarms that are not cleared. Current alarms are viewed using EMA and CLI.
To display the Current alarms using CLI, execute the following command:
| Code Block |
|---|
% show table alarms currentStatus |
The results display similar to the figure Current alarms (displayed in CLI mode):
| Caption | ||||||
|---|---|---|---|---|---|---|
| ||||||
To display the Current alarms using EMA,
On the SBC Main Screen, navigate to Monitoring > Dashboard > Alarms > Current Alarms
| Caption | ||||
|---|---|---|---|---|
| ||||
History Alarms
History Alarms provides historical information about the alarms which occurred on the system, such as the time when the alarms were added/updated/modified/cleared. Historical alarm details are displayed using CLI or from the EMA Dashboard.
For example, to display the list of alarms which occurred on the SBC, execute the following command from CLI:
| Code Block |
|---|
> show table alarms historyStatus |
The output is displayed similar to the figure below:
| Caption | ||||
|---|---|---|---|---|
| ||||
| |
To view the Cleared Alarms in the SBC EMA, from the EMA menu navigate to Monitoring > Dashboard > Alarms > Cleared Alarms.
| Caption | ||||
|---|---|---|---|---|
| ||||
|
The status of the alarms are also available in the following locations of the EMA:
Current Alarms - All > Alarms > Current Status
Caption 0 Figure 1 Current Status History Alarms - All > Alarms > History Status
Caption 0 Figure 1 History Status
For additional details with viewing alarms and configuring SBC for alarms, refer:
| Pagebreak |
|---|
Overview
Content Tools