Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_workflow_for_techpubs
AUTH2bscoggins
AUTH1sbsarkar
REV5dalves
REV6radaikalam
REV3dsevigny
REV1wkwak

Panel

In this section:

Table of Contents
maxLevel2

Info
iconfalse

Related articles:

Children Display

 

These objects specify the IP interfaces that the SBC will utilize for telephony, management, and system debugging traffic.

IP Interface Groups are a primary tool for accomplishing disjoint networks (administrative network separation). An IP Interface Group is the local manifestation of a segregated network domain.

Note
iconfalse
titleNote

For the SBC 52x0 platform, the IP Interface on the media ports 0 and 1 are considered as the first set (example: set 1) and the IP Interfaces on media ports 2 and 3 are considered as second set (Example: set 2). While associating the interfaces to an IP Interface Group, the IP Interfaces associated to the group must be from the same set (set 1 or set 2). This should be set at the configuration level.

Note
iconfalse
titleNote

When calculating bandwidth size, keep in mind that an IPv6 header size (40 bytes) is twice as large as IPv4 header (20 bytes), thus reducing the number of messages when using IPv6.

Include Page
Unique_IP_for_SigPort
Unique_IP_for_SigPort

Include Page
IP_IGs_ServedBySeperateProcessors
IP_IGs_ServedBySeperateProcessors

To View Ip Interface Group

On SBC main screen, go to Configuration > System ProvisioningCategory: Base Provisioning >Ip Interface Group. The Ip Interface Group window is displayed.

Caption
0Figure
1System Provisioning - Ip Interface Group

The Ip Interface Group can be checked for each Address Context or for all the Address Contexts created. Use the drop-down box to select the desired Address Context.

Caption
0Figure
1Ip Interface Group - Main Field

To Edit Ip Interface Group

To edit any of the Ip Interface Groups in the list, click the radio button next to the specific Ip Interface Group name.

Caption
0Figure
1Ip Interface Group - Highlighted

The Edit Selected Ip Interface Group window is displayed below.

Caption
0Figure
1Ip Interface Group Edit Window

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

To Create Ip Interface Group

To create a new Ip Interface Group, click New Ip Interface Group tab on the Ip Interface Group List panel.

Caption
0Figure
1Ip Interface Group fields

The Create New Ip Interface Group window is displayed.

Caption
0Figure
1Ip Interface Group Create Window

The following fields are displayed:

Caption
0Table
1Ip Interface Group Parameters

Parameter

Description

Name

The name of the IP interface group.

IPSec

The administrative state of a resource. Administrative state of the IPsec support for this interface group.
disable (default)—ipsec support is turned off for all interfaces in the group.
enable— ipsec support is turned on for all interfaces in the group.

Enter all the required fields. You can click Show only required fields at the left hand bottom of the panel to view and enter only the required fields to create a Ip Interface Group.

To Delete Ip Interface Group

To delete any of the created Ip Interface Group, click the radio button next to the specific Ip Interface Group which you want to delete.

Caption
0Figure
1Ip Interface Group - Highlighted

Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.

Caption
0Figure
1Ip Interface Group Delete Confirmation

Click Yes to remove the specific Ip Interface Group from the list.

Pagebreak