REST API Method: POST /rest/faxcodecprofile/{identifier}
Page Tree |
---|
root | Resource - faxcodecprofile |
---|
|
Modifies a FAX Codec Profile Table given a specific Table ID.
Note |
---|
|
The FAX Codec Profile identifier can only be within the range 1-9999 (inclusive) |
URL:
https://134.56.227.163/rest/faxcodecprofile/{identifier}
HTTP Method
POST
Requires Authentication:
true
Parameters
Parameter Name | Required | Service Affecting | Data Type | Default Value | Possible Values | Description |
---|
Description | No | No | string | none | 64 - Max Length | Identifies this profile so it can be easily recognized when selecting a codec. |
---|
FaxRelayFallBack | No | No | Enum | 0 | Possible values: - 0 - edtEnable
- 1 - edtDisable
| Specifies if the T.38 should fall back to Fax Passthrough if not supported by peer. |
---|
FaxRateInBitsPerSecond | No | No | int | 14400 | Possible values: - 2400 - Minimum
- 14400 - Maximum
| Specifies the maximum fax connection rate. Acceptable rate values are: - 2400
- 4800
- 7200
- 9600
- 14400
|
---|
SignalingPacketRedundancy | No | No | int | 3 | Possible values: | Specifies the number of redundant packets to be sent for each T.30 (signaling) message. |
---|
PayloadPacketRedundancy | No | No | int | 0 | Possible values: | Specifies the number of redundant packets to be sent for each packet containing page data. |
---|
ErrorCorrectionMode | No | No | Enum | 0 | Possible values: - 0 - edtEnable
- 1 - edtDisable
| Specifies the error correction mode (ECM) for fax calls. |
---|
TrainingConfirmation | No | No | Enum | 1 | Possible values: - 0 - tctLocallyGenerate
- 1 - tctSendOverNetwork
| Specifies the Training Confirmation (TCF) procedure for fax calls. - Locally Generate
- The TCF data is not passed across the IP network. Each gateway independently generates or checks the TCF and only the result of the training is passed over the network. - Send over the Network
- The TCF data is passed across the IP network in the same way as any other page data.
|
---|
Tip |
---|
|
The POST can contain either only the attributes that are being updated, or the full set of attributes for the resource |
Code Block |
---|
|
Put code example here |
Response:
Code Block |
---|
|
Put Code response here |