Versions Compared

Old Version 2

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 3

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Caption
0Figure
1System - Media - Media Peer Inactivity
 

Image Modified

The following fields are displayed:

Caption
0Table
1Media Peer Inactivity
 
Parameter

Description

Inactivity Timeout

Specifies the RTP/RTCP inactivity timeout value. The default value is 60 seconds. The valid range is between 20 to 1260 seconds. The timeout value must be a multiple of 10 seconds.

When both RTP and RTCP are enabled, timeout will only occur if both packet types remain undetected for the configured inactivityTimeout duration. If RTCP is not enabled, then only the absence of RTP causes the timer to expire. Specify timeout value in multiples of 10 (range: 20-1260 / default = 60).

Note

When using this feature, you must also set the "Peer Absence Action" flag from Packet Service Profile (see System Provisioning - Packet Service Profile).

When Media Peer Inactivity is enabled (configured with an Inactivity Timeout value), SBC detects media inactivity within the configured inactivity timeout value + X, and then executes the configured action (where X is from 0 - 10 seconds).


Make the required changes and click Save at the right hand bottom of the panel to save the changes made.