...
Image Modified
To Create Radius Server
To create a new Radius Server, click New Radius Server tab on the Radius Server List panel.
...
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Radius Server Fields |
|---|
|
| |
Image Modified
The Create New Radius Server window is displayed.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Radius Server Create Window |
|---|
|
| |
Image Modified
The following fields are displayed:
| Caption |
|---|
| 0 | Table |
|---|
| 1 | Radius Server Paramters |
|---|
|
| |
| Parameter | Description |
|---|
Server Name | RADIUS server name (up to 23 characters). |
Priority | When configuring multiple RADIUS servers, use this attribute to specify the order to attempt RADIUS authentication. The RADIUS server with the lowest priority is contacted first. |
State | Operational state of the RADIUS server. Options are
disabled (default)enabled
|
Radius Server IP | IPv4 address of the RADIUS server. Default value = 0.0.0.0 | Note |
|---|
IPv6 configuration for RADIUS server is not supported at this time. |
|
Radius Server Port | The RADIUS server port to which the SBC sends the request. Range: 1-65535. Default value = 1812 |
Radius Nas IP | IPv4 address of the SBC to send in ACCESS_REQUEST. Default value = 0.0.0.0 |
Radius Shared Secret | The shared secret used to encrypt the data exchanged between SBC and RADIUS server. Range: 8-128 characters |
Mgmt Interface Group | The Management Interface Group that is used to connect to RADIUS server. | Note |
|---|
In a SBC HA configuration, four management IP addresses must be listed on the RADIUS server: - mgt0 and mgt1 IP addresses of the Active CE
- mgt0 and mgt1 IP addresses of and Standby CE
|
|
To Copy Radius Server
To copy any of the created Radius Servers and to make any minor changes, click the radio button next to the specific Radius Server to highlight the row.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Radius Server Highlighted |
|---|
|
| |
Image Modified
Click Copy Radius Server tab on the Radius Servers List panel.
...
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Radius Server Fields |
|---|
|
| |
Image Modified
The Copy Selected Radius Server window is displayed along with the field details which can be edited.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Radius Server Copy Window |
|---|
|
| |
Image Modified
Make the required changes to the required fields and click Save to save the changes. The copied Radius Server is displayed at the bottom of the original Radius Server in the Radius Server List panel.
...
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Radius Server Highlighted |
|---|
|
| |
Image Modified
Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | Radius Server Delete Confirmation |
|---|
|
| |
Image Modified
Click OK to remove the specific Radius Server from the list.