Page History

Overview

The 

The

When configuring surrogate registration, only one of the following mutually exclusive parameters should be enabled at the IP Peer surrogateRegistration level depending upon the number of AORs per IP Peer desired.

• Only one AOR per IP Peer for surrogate registration—Configure only userPart at  the surrogate registration level. With this method, you cannot associate a surrRegprofile with this peer.
• Multiple AORs for IP Peer for surrogate registration—Associate more than one AOR to the same peer by configuring and attaching a surrRegprofile to the IP peer. When using this profile, you cannot configure userPart at the surrogate registration level.

A surrogate registration profile is added, modified and deleted as explained below. For additional feature details,

refer to Surrogate Registration Support.

Adding New Profile

1. Configure a new surrogate registration profile.
2. Enter various AOR username and corresponding details in this profile.
3. Attach this profile to given IP Peer (

1. refer Zone - IP Peer - CLI page).
2. Optionally configure pacing time at IP Peer (

1. refer Signaling - Global - CLI page).
2. Enable surrogate registration feature at IP Peer.

The SBC starts sending register messages using a randomized timer (unless surrogateRegisterPacingTime is configured).

Modifying Existing Profile

1. Set AOR state to 'disabled'.
2. Modify the configuration value of AOR.
3. Set the AOR state to 'enabled'.

The modified configuration takes effect from the next register onwards for the given AOR.

Deleting Existing Profile

1. Disable the surrogateRegistration state from IP Peer (see Zone - IP Peer - CLI page).
2. Detach the profile from ipPeer.
3. Remove the profile.

As soon as the administrator detaches the profile from ipPeer, all AORs in the profile are queued for De-registration. If profile is re-attached, a fresh registration request is queued. Note that the register will happen after all of the de-register requests resulting from detachment of the profile are executed. 

Command Syntax

The CLI syntax to configure the Surrogate Registration Profile is shown below:

% set profiles services surrogateRegistrationProfile <profile name> aorUserName <user name> 
	aorAuthPassword <6-32 characters>
	aorAuthUserName <1-127 characters>
	aorSendCredentials <challengeForAnyMessage | challengeForAnyMessageAndInDialogRequests | challengeForRegister>
	aorState <disabled | enabled>
	userEndRange <1-32>
	userStartRange <1-32>

Command Parameters

surrogateRegistrationProfile