Versions Compared

Old Version 3

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version 4

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Add_workflow_for_techpubs
AUTH1
REV5
REV6
REV3
REV1

Noprint
Panel
borderColorgreen
bgColortransparent
borderWidth2

Back to Profiles - CLI

Back to Signaling - CLI

Back to IP Signaling Profile - CLI

Back to IP Signaling Profile - H.323 - CLI

Panel

In this section:

Table of Contents
maxLevel2

 

This section lists CLI command syntax to configure common IP attributes for communicating with the peer regardless of call direction.

Common Syntax

Code Block
languagenone
% set profiles signaling ipSignalingProfile DEFAULT_H323 commonIpAttributes flags
	audioCodecChangeThroughEmptyTcs <disable | enable>
	clearmodeForDataCalls <disable | enable>
	disableConstrainedCapacities <disable | enable>
	includeG729WithG729aWhenOfferPspHasG729a <disable | enable>
	sendEmptyTcs <disable | enable>

Command Parameters

The IP Signaling Profile H.323 Common IP Attributes are as shown below:

Caption
0Table
1IP Signaling Profile H.323 Common IP parameters

Parameter

Description

audioCodecChangeThroughEmptyTcs

Enable flag to perform audio codec change (e.g. G.711 fax fallback) using empty Terminal Capability Set (TCS). When disabled, 

Spacevars
0product
performs audio codec change using request mode.

  • disable (default)
  • enable

clearmodeForDataCalls

Set flag to enable the clearmode function for data calls

  • disable (default) – If disabled for the SIP Egress call leg, legacy operation is signaled and payload type is assumed implicit (same on both sides). If disabled for the SIP Ingress call leg, legacy G.711 operation is accepted as well as Clearmode.
  • enable – If enabled for the SIP Egress call leg, Clearmode is sent using dynamic payload type. If enabled for SIP Ingress call leg, only Clearmode data calls are accepted.

disableConstrainedCapacities

Set this flag to present a full TCS to its peer during call setup or media modification. When disabled, 

Spacevars
0product
presents only the selected codec in the TCS, and follows up with a full TCS after media establishment.

  • disable (default)
  • enable

includeG729WithG729aWhenOfferPspHasG729a

Use this flag to control whether the H.323 Service Group includes G.729 along with G.729A in the network offer when the 

Spacevars
0product
offer Packet Service Profile has G.729A.

  • disable (default)
  • enable
sendEmptyTcs

Enable flag to send empty TCS to the peer to restart the peer’s forward channel in case there is an address update in the direct media case.

  • disable (default)
  • enable

Command Example

Code Block
languagenone
% show profiles signaling ipSignalingProfile DEFAULT_H323 
 ipProtocolType h323; 
 commonIpAttributes { 
 flags { 
 audioCodecChangeThroughEmptyTcs disable; 
 disableConstrainedCapacities disable; 
 includeG729WithG729aWhenOfferPspHasG729a disable; 
 sendEmptyTcs disable; 
 } 
 }

Pagebreak