Use this control control to set detection of Media peer inactivity (Inactivity Timeout value) which may be used in conjunction with packet loss rate parameter (Packet Loss Threshold) of a Packet Service Profile. Note that if Packet Loss Threshold is set to any value less than "400", it is considered as being set to “0” and no packet loss is detected. Thus, only Media peer inactivity will be is detected by the SBC.
On the SBC main screen, go to All > System >Media > Media Peer Inactivity. The Media Peer Inactivity window displays.
...
| Caption |
|---|
| 0 | Table |
|---|
| 1 | Media Peer Inactivity |
|---|
|
| |
| Parameter | Description |
|---|
| Inactivity Timeout |
|
...
Use this parameter to specify the RTP/RTCP inactivity timeout value. The default value is 60 seconds. The valid range is between 20 to 1260 seconds. The timeout value must be a multiple of 10 seconds. When both RTP and RTCP are enabled, timeout will only occur if both packet types remain undetected for the configured inactivityTimeout duration. If RTCP is not enabled, then only the absence of RTP causes the timer to expire. Specify timeout value in multiples of 10 (range: 20-1260 / default = 60). |
|
...
Behavior/conditions: - When using this feature, you must also set the Peer Absence Action flag from the Packet Service Profile (
|
|
...
...
- (0-10 seconds), and then executes the configured action
|
|
...
- .
- If a valid RTP stream does not send enough packets, use Media Peer Inactivity with RTCP only.
- If the endpoint does not send both RTP and RTCP packets frequently enough within the Inactivity Timeout duration,
|
|
...
- it is recommended to avoid using Media Peer Inactivity.
|
|
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.
...