Page History

...

1. Create a SIP signaling port on the SBC towards the recorder, and enable SIPREC.

   Code Block
   language none
   % set addressContext <ADDRESS-CONTEXT> zone <ZONE> sipSigPort <SIP SIGNALLING PORT> siprec enabled

   Note
   To support SIPREC INVITE over TCP, the sipSigPort, which is configured in the zone for SIPREC must have transportProtocolsAllowed as sip-tcp.

   Note
   % set addressContext <ADDRESS-CONTEXT> zone <ZONE> sipSigPort <SIP SIGNALLING PORT> transportProtocolsAllowed sip-tcp

2. Create a trunk group from the SBC for recording.

   Code Block
   % set addressContext <ADDRESS-CONTEXT> zone <ZONE> sipTrunkGroup <sipTrunkGroup>

   Note
   Ensure that the name of the trunk group must be identical to the one used above while creating Recorder profile on the PSX.

3. Add static routes toward the recorder.
   
   

4. Start recording from the CLI or EMA.

   Note
   When recording is initiated from CLI/EMA, disable call recording criteria (or check that call recording criteria does not match); otherwise, recording is not initiated through CLI/EMA.

    

   1. CLI method

      To configure siprec startRecord request, execute the following command both on the ingress and egress legs:

      Code Block
      language none
      % request global sipRec startRecord gcid <GCID> callLeg ingress trunkGroup <TRUNK GROUP NAME> srsIpAddress <SRS IP ADDRESS> srsPort <SRS PORT> transport <tcp | udp> % request global sipRec startRecord gcid <GCID> callLeg egress trunkGroup <TRUNK GROUP NAME> srsIpAddress <SRS IP ADDRESS> srsPort <SRS PORT> transport <tcp | udp>

   2. EMA method

      On the SBC main screen, navigate to All > Global > SIPrec. Select Start Record command from the commands drop-down list.

      Caption
      0 Figure 1 EMA Start Record Command

      Click startRecord.

5. To stop recording, use one of the methods below.

   1. CLI method:

      Code Block
      language none
      % request global sipRec stopRecord gcid <GCID>

   2. EMA method:

      On the SBC main screen, navigate to All > Global > SIPrec. Select Stop Record command from the commands drop-down list.

      Caption
      0 Figure 1 EMA Stop Record Command

      Click stopRecord.

6. To view the details of the calls being recorded from CLI or EMA

   1. CLI method:

      Code Block
      language none
      > show table global sipRecStatussiprecStatus RECORDER RX RTP TX RTP RECORDING GCID ADDRESS ADDRESS RECORDING GCID RECORDER ADDRESS RX RTP ADDRESS TX RTP ADDRESS LEG ------------------------------------------------------------------------------ 1 10.54.180.200:5070 10:2024 .54.80.200:13471 10.54.80.200:13467 ingress 131072 10.54.9680.8200:80005070 10.54.80.200:13471 10.54.9680.8200:800213467 ingress [ok]

   2. EMA method:

      On the SBC main screen, navigate to All > Global > SIP rec Status
      

      Caption
      0 Figure 1 SIPREC Status Example
      Image Added