| Noprint |
|---|
| Panel |
|---|
| borderColor | green |
|---|
| bgColor | transparent |
|---|
| borderWidth | 2 |
|---|
| Back to |
|
...
Back to CLI Configure Mode
...
...
This section lists CLI commands to configure ingress IP attributes.
Command Syntax
| Code Block |
|---|
% set profiles signaling ipSignalingProfile DEFAULT_H323 |
...
...
...
convertProgressToAlert <disable | enable>
|
...
dontSendFacilityMessage <disable | enable>
|
...
refuseFastStartProposal <disable | enable>
|
...
send183OnInitiatingDisconnectTreatment <disable | enable>
|
...
sendFastStartResponseInCp <disable | enable> |
Command Parameters
The IP Signaling Profile H.323 Ingress IP Attributes flags are shown below:
| Caption |
|---|
| 0 | Table |
|---|
| 1 | IP Signaling Profile H.323 Ingress IP Parameters |
|---|
|
|
...
Length/Range
Description |
|---|
convertProgressToAlert
|
|
...
| Set this flag to convert Progress messages to Alert messages when communicating to endpoints that have difficulty with Progress messages. | dontSendFacilityMessage
|
|
...
N/A
Set this flag to prevent sending Facility messages to endpoints that do not tunnel and have difficulty processing Facility messages. | refuseFastStartProposal
|
|
...
| When this flag is set, does not include FastStart proposal in early media calls. Instead, it relies on H.245 procedure to complete media setup. When cleared, always includes fast start proposal in SETUP message for early media calls. | send183OnInitiatingDisconnectTreatment
|
|
...
N/A
Enable this flag to send a 183 message on initiating a disconnect treatment. | sendFastStartResponseInCp
|
|
...
| When this parameters is used, the sends a |
|
...
Fast start response message in Call Proceeding messages. |
|